INITIAL OPERATION Fill the tank with 14.5 gallons of water. DO NOT OVERFILL THE TANK. Moving a fan with a full tank can be difficult. It is recommended that you place the fan then fill it with water. Lock the casters. Then plug the CoolBox into an outlet.
Page 3
1.Press ON/OFF button to turn on the unit. Press this button again to off the cooler. 2.Press COOL button once to start the evaporative cooling function. The water pump will operate, note that there is a delay of one minute before the fan starts while the cooling pads get wet, and you will feel the cooler air after the Honeycomb Cooling Media is completely wet.
Page 4
Wind indicator turns when fan is in operation. Cooling Indicator Water level Speed Indicator Indicator (1 low, 2 med, 3 High) Power Will flash red Indicator when water levels are low Blast – Fan only unit not Timer cooling. Indicator Remote receiver (not a button)
SHUTDOWN PROCEDURES 1. Turn off the cooling function on the CoolBox. 2. Let the fan run so to dry out the pad. (Approx. 20 minutes) 3. After the pad have dried unplug the CoolBox. 4. Drain all water from the tank. 5.
BASIC TROUBLESHOOTING BEFORE performing any internal maintenance, make sure your CoolBox unit is powered OFF and UNPLUGGED! As general rule of thumb if your CoolBox is not functioning unplug the unit and wait one minute before attempting any of the solutions below. Malfunction Reason Remedy/Solution...
KEY FEATURES Effective and Economical • Energy-saving and environmentally friendly • Reliable operation • Cools a large area • Quiet running • Adjustable speed • Full function remote control • Large water tank for extended time between • fills No need for compressed air •...
Need help?
Do you have a question about the CoolBox C1530 and is the answer not in the manual?
Questions and answers