iOttie Auto Sense Manual

Getting Started

For optimal mounting and charging, please follow the detailed instructions within this manual when using the Auto Sense Wireless Charging Mount. iOttie is not liable for possible damages due to product misuse.

Critical Information
Mounting at a perpendicular angle to the mount works best with the proximity sensor.

If mounting at an angle, phone will need to be very close to sensor for arms to open.

Smartphone cases
Reflective smartphone cases work best. Dark colored or textured cases do not reflect light well, making it difficult for the proximity sensor to detect the phone. If using a dark colored or textured case, the phone will have to be very close to mount for arms to open automatically.

Compatibility
The Auto Sense is compatible with all Qi-enabled smartphones including Google, Apple, & Samsung devices. (Qi charging speed is dependent on the phone make and model.)

Qi Wireless Charging in Vehicle
Use the included iOttie car charger and micro USB cable. If you use a third party car charger, ensure that it is Qualcomm Quick Charge 2.0 or above.

At a Glance

Qi Alignment Guide

The Qi receiver coil is usually located in the center area of the phone. Check with your phone's manufacturer for Qi coil location. Below are some examples for commonly used phones.

For optimal wireless charging, please make sure your smartphone and mount's Qi coils are aligned.

Adjusting the Mount

1. Foot Knob
   The bottom foot is set to fit standard-sized smartphones. If you have a larger phone or use a thicker case, you can adjust the foot to accommodate your phone.
   To adjust the foot, simply move the knob down until it aligns with the appropriate size marking as shown in the line drawing.
   

Connecting to Power

1. Plug the micro-USB cable into the USB port on the back of the mounting head.
   
2. Insert the car charger into your vehicle's power port.
   

Installation

CD Slot Mount

1. Attach the CD mount to the cradle. Tighten using the adjustment knob.
   
2. Put the mount into the CD slot and pull the lever to lock it into place.
   
3. Test to make sure the mount is secure. Insert bracket only if needed.
   * If using the bracket, make sure the arrow is pointing inward.
   
4. Align your smartphone in the center of the cradle. The indicator light will turn on when the phone is successfully charging.
   

To avoid possible damage to the product and your vehicle, remember to remove all CDs from the CD slot before using your Auto Sense Mount. iOttie is not liable for damage due to misuse.

Air Vent Mount

1. Attach the air vent mount to the cradle. Tighten using the adjustment knob.
   
2. Loosen the twist lock and push the mount completely onto the air vent blade.
   
3. Slowly tighten the twist lock to ensure a secure connection to the air vent blade.
   
4. Align the smartphone in the center of the cradle. The indicator light will turn on when the phone is successfully charging.
   

Please use caution when adjusting the twist lock on the air vent blade.

Using the Product

Mounting and Charging

1. The side arms will automatically open via a silent servo motor when a phone is detected by the proximity sensor.
   
2. Once the phone is placed inside the mount, the arms will automatically close for a secure hold. Qi wireless charging will start immediately.
   

Releasing Device

Use the buttons located on both side of the mount cradle to open the arms and retrieve your device. These buttons can also be used to close the device.

*The Auto Sense is powered via a micro-USB cable. There is no on/ off switch on the mount. Once it is plugged in, the mount will remain on unless the vehicle is turned off.

Wireless Charger Specifications

Car Charger Specifications

Charging Indicator

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download iOttie Auto Sense Manual