Nexigo Meeting 360 Ultra - Enhanced All-in-One Conference Camera Manual

SETUP INSTRUCTIONS

Before you plug in the NexiGo Meeting 360 Ultra, choose an Input Mode: USB, HDMI, or LAN Mode. This will determine how you set up the camera and how you will be able to use it.

Note that you can only use one Input Mode at a time. If multiple inputs are connected, the system will default to HDMI Input Mode.

USB MODE

Use the NexiGo Meeting 360 Ultra as a webcam on your computer.

Setup

1. Use the provided USB-C to USB-C Cable to connect the camera to power.
   

2. Connect the camera to a computer using the provided USB-A to USB-C cable.
   

3. Press and hold the Power Button for at least 5 seconds to power on the camera.
   

4. To pair the remote control, simultaneously press and hold the OK and Volume Down Button for at least 5 seconds.
   

HDMI MODE

Use the NexiGo Meeting 360 Ultra as an independent video conferencing terminal.

In this mode, it's unnecessary to use an external computer. Simply connect the NexiGo Meeting 360 Ultra to a TV or other display screen and start video conferencing directly through the camera.

Setup

1. Use the provided USB-C to USB-C Cable to connect the camera to power.
   

2. Use an HDMI cable (not included) to connect the camera to a TV or other external display.
   

3. Press and hold the Power Button for at least 5 seconds to power on the camera.
   

LAN MODE

Use the NexiGo Meeting 360 Ultra as an independent video conferencing terminal for local meetings.

NexiGo Meeting Studio can integrate up to four video conferencing cameras at once, enabling image and audio capture throughout a wider area.

Make sure the camera and computer are on the same network.

Setup

1. Use the provided USB-C to USB-C Cable to connect the camera to power.
   

2. Use an Ethernet Cable (not included) to connect the camera to a router. Connect up to four NexiGo Meeting 360 Ultra cameras to the same network as the meeting host computer.
   

3. Press and hold the Power Button for at least 5 seconds to power on the camera.
   

4. To control the camera, download the NexiGo Meeting Studio App at
   nexigo.com/pages/n2000-ultra-support
   

PAIRING REMOTE

Ensure that you point the remote toward the camera and simultaneously press and hold the OK and Volume Down Button for at least 5 seconds until the indicator stops flashing to pair the remote with the camera.

NOTES

• The remote control can only control the system in HDMI and USB Input Modes.
• In USB Input Mode, only buttons labeled 2, 5, 6, 4, 11, and 12 are functional.
• The Remote Control cannot power on the NexiGo Meeting 360 Ultra. Please power on the device manually, then press and hold the Power Button for at least 5 seconds to activate the camera.
• Two AAA batteries (not included) are required to power the Remote Control.
• If the Remote Control is unable to control the camera, connect a mouse to the USB-A Port on the back of the camera. To attempt to repair the Remote connection, use the mouse to navigate to Settings > Bluetooth > Paired Devices and delete the paired Remote Control. Then, press and hold the OK and Volume Down Buttons on the Remote Control for at least 5 seconds. The indicator will stop flashing to signal that the Remote Control is once again connected to the NexiGo Meeting 360 Ultra.
• Press the Air Mouse Button on the Remote Control to use motion controls. This setting will display a small arrow cursor on the desktop, which you can control by pointing the Remote Control at the screen. When motion control is active, the Left / Right / Up / Down Buttons and the Power button on the remote control will be disabled.
• To power off the camera or enter standby mode, you must exit motion control mode.