BPS Storm, BPS-33-BB-BluePurple - Bodyboard Manual

HOW TO INSTALL YOUR LEASH

1. Thread into and then pull the corded end of the leash through the leash plug. If this is difficult you can carefully use something small (but blunt!) to push this through. Then, pull the cord through and open into a loop.
   
2. Then feed the other end of the leash (with the wrist cuff) through this loop. Pull all of the leash through – until it is then quite a tight knot.
   
3. Ensure that it is quite a tight knot. Then, your leash is fitted and ready to use!
   

You are all set up!

Here are some more helpful tips on how to look after your board:

1. When on the beach and there's no shade to protect your board from the sunlight, you can cover it up with a towel.
2. Always wash your bodyboard with fresh water every after use.
3. Always make sure that you lay the board flat when you store it to maintain its shape and to avoid being bent when not in use.
4. Avoid leaving your bodyboard at a place with intense heat or facing directly to the sunlight. This will cause the board's surface to bubble and get damaged.

I really hope these instructions have been helpful. Please know that we are also an email away for any other questions you may have with your bodyboard. Thank you and see you on the water!