Advertisement
ReGen8 Solo 2 - 1 Person 1410W Infrared Sauna
ReGen8 Duo 2 - 2 Person 2040W Infrared Sauna
ReGen8 Trio - 3 Person 2520W Infrared Sauna
ReGen8 Quadro - 4 Person 2640W Infrared Sauna
Product may vary slightly from the item pictured due to model upgrades.
Read all instructions carefully before using this product.
Retain this owner's manual for future reference.
NOTE:
This manual should not be used to guide your purchasing decision. Your product, and the contents inside its carton, may vary
from what is listed in this manual. This manual may also be subject to updates or changes. Updated manuals are available
through our website at
www.lifespanfitness.com.au
Regen8 Sauna
USER MANUAL
Find the
Digital Manual
Online
Advertisement
Table of Contents
Related Manuals for LifeSpan Regen8 Solo 2
Summary of Contents for LifeSpan Regen8 Solo 2
- Page 1 Regen8 Sauna ReGen8 Solo 2 - 1 Person 1410W Infrared Sauna ReGen8 Duo 2 - 2 Person 2040W Infrared Sauna ReGen8 Trio - 3 Person 2520W Infrared Sauna ReGen8 Quadro - 4 Person 2640W Infrared Sauna Find the USER MANUAL...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Important Safety Instructions ....... 03 II. Installation Procedure ........04 III. -
Page 3: Important Safety Instructions
I. IMPORTANT SAFETY INSTRUCTIONS For your safety, it is crucial to adhere strictly to the following precautions while using this product: 1. Ensure that children use the equipment under the supervision of an adult. Avoid playing with the equipment for safety reasons. 2. -
Page 4: Installation Procedure
II. INSTALLATION PROCEDURE a. Do not plug any other appliances into the outlet. b. Install the sauna on a completely level floor. c. Do not spray the exterior with water. If the floor is damp, install a floor separator to keep the sauna high and dry. -
Page 5: Assembly Instructions
III. ASSEMBLY INSTRUCTION STEP 1. BOTTOM FLOOR ASSEMBLY Place the bottom board (Sauna room diagram,) in the desired location of your sauna, and identify the front and back sections. STEP 2. BACK BOARD ASSEMBLY A. Align the backboard (section 8) with bottom board’s corresponding battens. Ensure they are in line. B. - Page 6 STEP 3. LATCH ASSEMBLY The latch features a guide tab that needs to be aligned with the guide slot. Hold the back panel upright against the floor panel, carefully placing the tab into the slot without latching it yet. Once the back wall, front wall, and side wall are properly positioned on the floor panel, you can close and secure the latches with pins.
- Page 7 STEP 5. LEFT BOARD ASSEMBLY Align the left board (section 1) with the corresponding battens on the bottom board, ensuring it fits flush against the backboard. Once aligned, secure them together by latching. STEP 6. FRONT BOARD ASSEMBLY Align the front board (section 3) with the corresponding battens on the bottom board. Then, latch it securely to the left and right boards.
- Page 8 STEP 7. TOP BOARD ASSEMBLY Position all wires outside to ensure enough space for setting up the top board (section 9). Open the door, raise the top board high enough to check if it aligns with the surrounding boards, then carefully lower it into place.
- Page 9 Next, feed the power plugs for the speakers, temperature sensor, and control panel through the hole in the top board. Guide the wires down into the sauna cabin. Connect all wiring from the top board to the corresponding connectors for the control panel, temperature sensor, and radio antenna.
- Page 10 Once all steps are completed correctly, plug in the power and test the sauna to ensure it operates properly. After confirming its functionality, place the external top board (section 10) over the internal top board, and thread the power plug through the corresponding hole in the external top board.
- Page 11 1. PRECAUTIONS a. Ensure all circuitry and plugs comply with safety standards and requirements. b. Set the temperature and time to a comfortable level before starting the session. c. Drink a glass of water before beginning your sauna session. d. After 2 hours of continuous use, allow the sauna to cool down by shutting it off for at least one hour. e.
-
Page 12: Control Panel Operation
IV. CONTROL PANEL OPERATION Controller Brief Description 1. ON/OFF Button: ON: When you plug the unit into the electrical outlet, the power indicator will flash. Press the ON/ OFF button to turn the sauna on immediately. The LCD will display the last used settings for both temperature and time. - Page 13 4. Fahrenheit/Celsius Settings: When adjusting the temperature, press both the [up] and [down] buttons simultaneously to toggle between Fahrenheit and Celsius. 5. Reading Light Control: In normal operation, press the light button once to turn the reading light on. Press it again to turn the light off.
- Page 14 9. Bluetooth: - Press the button three times to enter Bluetooth mode. The screen will display "B-". After hearing a sound, search for the Bluetooth name on your mobile device to connect. - Once connected, you can play music from your mobile phone. Use the play/pause button to control playback.
- Page 15 Safety Precautions a. To avoid the risk of fire, do not dry clothes or leave towels inside the sauna. b. To prevent burns or electric shocks, avoid touching or using metal tools on the net cover of the Carbon heater elements. c.
-
Page 16: Troubleshooting
The heater is broken Replace the heater with a new The heater’s lifespan has one of the same specifications decreased from frequent use Carbon heater is not Replace the fuse with one of the... -
Page 17: Maintenance
VI. MAINTENANCE CLEANING: - Clean the faceplate using a damp towel. If necessary, use a small amount of hand soap mixed with warm water. - Clean the sauna room with a damp cotton towel and dry it with a clean, dry towel. - Do not use benzene, alcohol, or strong cleaning chemicals on the sauna, as they may damage the wood and its protective layer. -
Page 18: Warranty
Any claim against this warranty must be made through your original place of purchase. Proof of purchase is required before a warranty claim may be processed. If you have purchased this product from the Official Lifespan Fitness website, please visit https://lifespanfitness.com.au/warranty-form For support outside of warranty, if you wish to purchase replacement parts or request a repair or service, please visit https://lifespanfitness.com.au/warranty-form and fill in our Repair/Service... - Page 20 WWW.L IF ESPAN F ITNE S S . COM . A U...
Need help?
Do you have a question about the Regen8 Solo 2 and is the answer not in the manual?
Questions and answers