Advertisement
If your cable box has its own remote
to change channels, you will
probably be able to program the TV's
remote to control both the TV and
the cable box.
The TV's remote is designed to
control several brands of cable
boxes. To program the remote, just
press CABLE, then ID, then the two-
digit code number for your brand of
cable box.
Refer to the chart below
to find the code number for your
cable box. Press the OFF/ON button
next to confirm operation.
You may need to try each of the code
numbers listed for your brand until
you find the one that works.
After the TV's remote is
programmed, you'll be able to turn
on the cable box by pressing CABLE,
then OFF/ON. You can change
channels on the cable box by
pressing the CHANNEL buttons
whenever the remote is in the "cable"
mode. To put the remote in the
"cable" mode, press the CABLE
button. Press the TV button to put
the remote back into the TV mode so
the remote buttons will control the
TV again.
Cablestar.. ...................................................................................
Eagle.. ..............................................................................................
Eastern International
......................................................................
General
Instrument ......................................
Hamlin ..................................................................................
Hitachi. ......................................................................................
Jerrold.. ........................................................
M A C O M . ..................................................................................
Magnavox.. ........................................
NSC.. ..............................................................................................
Oak. ......................................................................................
Oak Sigma.. ....................................................................................
Panasonic.. .................................................................................
Refer
Note:
to the information sheet packed with your remote control for the latest list of brand names and code numbers. Because this list
growing, the information sheet packed with your remote control may be a later version of this list and contain additional
brands and/or code numbers.
34
Programming Remote To Control Cable Box
-(with remote only)
1. Refer to the chart below to find the
code number that corresponds to the
brand name of your cable box. Keep
this number in mind. If more than
one number is listed, you may need
to try each one separately until you
find the one that works.
2. Press CABLE button on remote.
3. Press ID button on remote.
4. Press two number buttons (first one,
then the other) to enter the code
number for your brand of cable box.
Note: You must press the two number
buttons within three seconds of pressing
the ID button.
Philips.. ..............................................
Pioneer........................................................................................
08
Randtek.......................................................................................
RCA.. ..............................................................................................
Regal.. ........................................................................................
Regency.. .........................................................................................
Scientific Atlanta.......................................................................
Sylvania.. ........................................................................................
Teknika.. ..........................................................................................
Texscan.. .....................................................................................
Tocom .........................................................................................
Unika ..............................................................................................
Zenith .........................................................................................
5. Point the remote at the cable box and
press the OFF/ON button to test the
code number.
If the right number was entered, the
l
cable box should turn on. Pressing
the CHANNEL buttons should then
cable box.
If the cable box does not react to
l
the remote (or if the remote turns
on the cable box but does not
change channels), repeat steps 1
thru 5 with another code number.
Operating Notes:
After the remote is programmed, it will
l
turn on the cable box whenever you press
CABLE and then OFF/ON.
To turn off the cable box, press CABLE,
l
then OFF/ON.
To change channels on the cable box,
l
press CABLE then CHANNEL up or down.
You may have to reprogram the remote
l
control if you change its batteries. Try
not to press any buttons while changing
18.20
02
06
Advertisement
