Advertisement
Separate the Tank from the Base of the unit
Flip over Water Tank and open the Tank Cap, turning it to the left
Pour cool, clean Distilled Water directly into the Tank
Close the Tank Cap, turning it to the right. FIRMLY secure Cap
The Mist Outlet can be turned 360˚
Pull out the Drawer and add a few drops of aroma oil to the Aroma Pad
Remove the Tank and empty all water from unit Base and Tank
Use ONLY the enclosed Cleaning Brush to gently clean disk
To reduce the risk of electrical shock and fire please observe the following instructions:
SERVICING: For servicing, other than general user maintenance, please contact Customer Service at (800) 233-0268, Monday through Friday, from 8am-5pm Eastern.
STORAGE: Store the Humidifier with these instructions, in the original carton in a cool, dry place.
PROBLEM | SOLUTION |
Water vapor and humidity are not produced. | Power plug: Unplug and then try again. Power Failure: When the power is returned, try again. Tank Installation: Make sure the tank is correctly attached. The surface of the ultrasonic disk is dirty: Clean ultrasonic disk. |
Air blows but water vapor is not produced. | Excessive Water: Empty base. Reinstall filled water tank. Detergent residue and/or oil ingredients from cosmetics, etc may be in tank; wash out tank and try again. The surface of the ultrasonic disk is dirty: Clean ultrasonic disk. If you use hard water, replace with distilled water. |
The humidity has a bad smell. | Poor maintenance or dirty water: Clean the product thoroughly, and fil it with fresh water. |
White dust is forming on nearby furniture. | Hard water may deposit a certain of dust. Dust in the air also settles because of added humidity in the room. Use only distilled water in this product, which will prevent this issue. |
Unit has stopped working. | No or low water. Unplug unit and refill tank. |
Water is accumulating outside of unit or area surrounding unit. | Saturation of humidity. Lower mist control setting. Unit not level and water is accumulating. Unplug and place on level surface. Point spray away from objects. Raise unit on a water-resistant level surface 2-3 feet off of floor. |
Water dripping when refilling. | Water remaining on bottom of tank. Wipe tank or tilt to drain before transporting. |
Increased noise level. | Unit must be placed on a flat, level, hard surface. Make sure it is NOT placed on a soft or absorbent surface. |
Red light on power dial. | Indicates low water. Unplug and refill tank. |
When using electrical appliances, these instructions and warnings should always be followed to reduce the risk of fire, electrical shock and injury to persons:
Read all instructions before using this Humidifier.
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, ALWAYS FOLLOW THESE IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS:
ALWAYS be sure the plug fits tightly into the outlet. When plugs fit loosely into outlets, they may slip partially out of the outlet and create a poor connection. This may cause outlets to overheat and create a potential fire hazard. Outlets in this condition should be replaced by a qualified electrician.
ALWAYS unplug the power cord when servicing, cleaning or moving the Humidifier. DO NOT use the ON/OFF switch as the sole means of disconnecting power. NEVER leave children unattended when the Humidifier is on or plugged in. ALWAYS turn off and unplug the Humidifier when not in use.
BE CERTAIN that the power source for the Humidifier is 120V AC. DO NOT plug the Humidifier into 240V or other power source.
The Blue Plug™ on your Lasko Humidifier is a safety feature. It contains a non-replaceable safety device (fuse) that should not be removed or tampered with. To reduce the risk of fire, electric shock and personal injury, DO NOT attempt to remove, replace, repair or tamper with the originally supplied plug. If the Humidifier has stopped functioning, it may be due to the safety device incorporated in this plug.
THIS HUMIDIFIER HAS A POLARIZED PLUG (one blade is wider than the other). This plug is designed to fit into the outlet only one way. Match the wide blade to wide slot in outlet and FULLY INSERT. DO NOT attempt to bypass or defeat this safety feature. If the plug does not fit in the outlet, consult a qualified electrician. The outlet may need to be replaced.
USE ONLY DISTILLED WATER IN THIS PRODUCT.
REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK - DO NOT USE THIS HUMIDIFIER WITH ANY SOLID STATE SPEED CONTROL DEVICES.
Register Your Product Today
www.lasko.com/product-registration
You will benefit from:
CUSTOMER SERVICE:
Toll-Free (800) 233-0268. Email: producthelp@lasko.com
Our Customer Service team is available to assist you with product and service questions, and replacement parts. They can be reached Monday through Friday, 8am-5pm Eastern. Please have your model number available, as well as the type and style (located on the underside of your product).
Customer Service Dept., 820 Lincoln Ave., West Chester, PA 19380
(Please do not send product to this location)
www.lasko.com
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the UH200 and is the answer not in the manual?
Questions and answers