Related Manuals for Energizer EZLSPF20S
Summary of Contents for Energizer EZLSPF20S
- Page 2 Energizer and certain graphic designs are trademarks of Energizer Brands, LLC and related subsidiaries and are used under license by Builder SAS. All other brand names are trademarks of their respective owners. Neither Builder SAS nor Energizer Brands, LLC is affiliated with the respective owners of their trademarks.
- Page 3 Thanks for choosing the EZLSPF20S Series! You're excited to power up, so we'll keep this brief. Let's get started!
-
Page 4: Safety Instructions
12. Do not use alcohol, flammable solutions or other solvents nearby or for cleaning of the warning light. Only clean the warning light with warm water and a soft cloth. 13. KEEP OUT OF REACH OF CHILDREN. SPECIFICATIONS: Model: EZLSPF20S/EZLSPF20SUK Voltage: 220-240V˜50/60Hz Power: 20W Degree of protection: IP65... - Page 5 A: Protective glass shield B: LED light source C: Sensor D: Cable E: Motion detector adjusting screw F: Adjustment knobs F1: Illumination period adjustment knob (TIME) F2: Sensor adjustment knob (SENS) F3: Daylight sensitivity adjustment knob (LUX) G: Handle H: Plug...
-
Page 6: Operation
ASSEMBLY INSTRUCTIONS Fasten the light to the “H” Stand (I) with the Knob (J) as shown and tighten. Note the round washer located on top of the Bracket (K). OPERATION Plug power cord into 220-240V standard wall outlet. The work light will be on. Warning: Replace any cracked protective shield! Loosen the knobs on sides to adjust the angle of the light head to aim light where needed. - Page 7 Adjusting the sensor light angle Adjust the sensor light angle before you adjust the sensor. Proceed as follows to adjust the light: 1. Loosen the screws at right side of the bracket. 2. Tilt the light to the required angle. 3.
Need help?
Do you have a question about the EZLSPF20S and is the answer not in the manual?
Questions and answers