Panasonic SC-AK240 Operating Instructions Manual page 11

Cassette tape – Play and record (Continued)
Press [0 OPEN] for DECK 1 or [OPEN 0] for DECK 2
2
and insert the cassette.
Insert with the side to be played facing towards you
and the exposed tape facing down. Close the holder by
hand.
3 Press [3, TAPE] to start play.
To Action
Press [ 7, STOP].
stop tape playback
Press [4 / REW / ] or [ / FF / ¢].
fast-forward and
rewind
select between Press [DECK 1/2] (remote control :
loaded decks [PLAY MODE]).
Note:
• Tape playback is momentarily interrupted if you open the other
deck.
• Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
• Tape slack can get caught up in the mechanism and should be
wound up before the tape is played.
• Endless tapes can get caught up in the deck's moving parts if used
incorrectly.
Recording Recording
Selection of tapes for recording
Use normal position tapes.
High position and metal position tapes can be used, but this
unit will not be able to record or erase them correctly.
Preparation
Wind up the leader tape so recording can begin
immediately.
Press [OPEN 0] for DECK 2 and insert the cassette
1
to be recorded.
Insert with the side to be recorded facing towards you
and the exposed tape facing down.
Select the source to be recorded.
2
Radio recording:
Tune in the station. (\ page 12)
Disc recording:
➀
Insert the disc(s) you want to record.
Press [6, CD] and then [7, STOP].
➁
Prepare the desired disc recording mode.
To Action
record
programmed
Perform steps 2 to 4 in "Program play"
tracks
(\ page 8).
Perform steps 3 to 6 in "Program play"
(\ page 8).
Front
side
Tape-to-tape recording:
➀
➁
Press [¶, REC] to start recording.
3
Other basic operations Other basic operations
To
stop recording
record on the other
side of the tape
erase a recorded
sound
Note:
• Changes to volume and sound adjustments quality do not affect
recording.
• You cannot open DECK 1 while recording.
• You cannot fast-forward or rewind one deck while recording with
the other.
Erasure prevention Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
By remote control only
record 1) Press [DISC] and then [1] ~ [5] to select
specifi c the disc.
discs/tracks Ensure disc is stopped.
2) Press [PLAY MODE] to select the desired
mode (\ page 7).
3)
For 1-ALBUM mode and 1-SONG mode:
Press [ALBUM (
album.
For 1-SONG mode:
Press [4, REW / ] or [¢,
select the track.
Press [3, TAPE] and then [7, STOP].
Press [0 OPEN] for DECK 1 and insert the cassette
to record.
Action
Press [ 7, STOP].
Turn the cassette over and press [¶, REC].
1) Press [3, TAPE] and then [ 7, STOP].
2) Insert the recorded cassette into
DECK 2. Ensure there is no cassette in
DECK 1.
3) Press [¶, REC].
Side A
Tab for side B Tab for side A
To re-record
Normal cassette
Adhesive tape
or )] to select the
/ FF] to
11
RQT8043