Hubbel KIM LIGHTING Ravenna KLV Series Installation Instructions

Ravenna KLV Installation Instructions
™
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS: Do not overdrive fixtures with
!
greater than 12 volts or fixture over-heating and short lamp life will occur. Do not overload the
transformer by installing (or relamping) higher wattage lamps than planned. Note: Total wattage of
all lamps connected to one transformer must not exceed the capacity of that transformer. Do not
install luminaire within 10 feet (3.04m) of a pool, spa or fountain. Lighted lamp is HOT.
SAFETY WARNING: When relamping, be sure electrical supply is OFF. Low voltage fixtures can
!
become very hot depending on the lamp wattage used. Glass lenses and metal areas above &
around the lamp can become hot enough to blister hands. Use discretion when touching fixture and
be sure to allow fixture to cool before relamping. When relamping fixture avoid touching the lamp
envelope with bare hands. If touching the lamp is necessary during installation, clean the envelope
with alcohol and dry with a clean, soft cloth before turning ON. Contamination of the envelope may
reduce lamp performance.
MAINTENANCE: To maintain light efficiency and prevent fixture-overheating, glass lenses and
enclosure must be kept clean and free of dirt, dust, leaves, trash (combustible materials) and mineral
deposits from water. Particular care should be taken not to locate fixtures where small children can
reach them if higher wattages are used.
Note: Keep the lamp free from impact while burning, as this may deform the filament and shorten the
lamp life. NOT INTENDED FOR INDOOR USE. All electrical work should be done by a qualified
electrician.
Unit intended for mounting with Diffuser/Glass Barrier and Lamp Holder greater than 2 in. (5.08 cm)
from the ground plane.
KEEP THIS SHEET FOR FUTURE REFERENCE.
Tools Required:
B" Hex Wrench
Silicone Grease F" Hex Wrench
Installation Instructions:
Step 1 - Tighten coupling onto mount-
ing device*.
* Consult KIM Landscape Catalog for
mounting device options.
Revision 10/14/11 EC 111014007
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861
IMPORTANT SAFETY INSTRUCTIONS!
5 /64 " Hex Wrench
Adjustable Wrench
!
Make certain the electrical supply is OFF before starting fixture installation.
Step 2 - Install fixture onto coupling.
Attach fixture cable to main system
cable with a KLV410 connector.
Status 12
KLV270
KLV271
KLV275
KLV276
Your KIM fixture is supplied with K "
NPSM male mounting threads.
Top Cap
Fixture Cable
Step 3 - Loosen two allen head
Spear screws and remove fixture head cap
carefully ensuring socket wires are
not damaged.
Additional wire and connectors may be
purchased from Kim Lighting:
KLV170
KLV171
KLV175
KLV176
KLV427 #12-2 Cable
KLV432 #8-2 Cable
KLV410 Connector
KLV411 Connector
Part No. 95587