Hubbel KIM LIGHTING LIGHTVAULT LTV50 Series Installation Instructions

LIGHTVAULT
®

INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS

WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.
!
Failure to take these steps may result in serious personal injury. Lighted lamp is HOT! Do not touch hot
lens, guard, or enclosure.
MAINTENANCE: A regularly scheduled maintenance program should be established to retain optimum light
output and reduce heat retention. Dusting with a clean, dry cloth is normally sufficient for the reflector.
KEEP THIS SHEET FOR FUTURE REFERENCE.

Tools Required:

Phillips Screwdriver

REFLECTOR INSTALLATION:

1. Attach quick-disconnect on reflector assembly to mating quick-disconnect inside housing.
2. Loosen rotational locking screws (do not remove) and slide locking screws toward center.
3. Install reflector assembly into housing.
4. Install lamp of type and wattage shown on fixture label.
5. Loosen tilt adjustment screw (vertical lamp reflectors only) and adjust to desired angle. Tighten tilt adjustment
screws.
6. Rotate reflector assembly to desired orientation. Slide rotational locking screws outward and tighten to lock
position of reflector.
7. Install lens frame per lens frame installation instructions.
VERTICAL LAMP REFLECTORS
WARNING:
The H.I.D. / Fluorescent fixture utilizes a lamp that may
contain mercury. For information on disposal of lamp, go
to website: www.lamprecycle.org
Revision 7/16/10 ECN 100715008
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861
- Reflector - LTV50 Series Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS!
Flat Blade Screwdriver
!
Make certain the electrical supply is OFF before starting fixture installation.
Tilt Adjustment Screw
(Phillips Screwdriver)
Rotational Locking Screw
(Flat Blade Screwdriver)
Status 14
Lift Up On Glare Shield to Remove or Install Lamp.
Rotational Locking Screw
(Flat Blade Screwdriver)
Lamp Support Ring
HORIZONTAL LAMP REFLECTORS
LTV50
SERIES
Remove This Shield For Lamp
Access. Shield Is Held In Place
By Two Dart Fasteners.
Part No. 95570