Panasonic WV-NS202A Network Operating Instructions page 62

Configure the settings relating to Panasonic alarm protocol
Click the [Notification] tab on the "Alarm setup" page. ( pages 20 and 21: How to display/operate the setup menu)
I Panasonic alarm protocol setup
The settings relating to Panasonic alarm protocol can be configured in this section.
[Panasonic alarm protocol]
Select "ON" or "OFF" to determine whether or not to
provide notification of an alarm occurrence by
Panasonic alarm protocol when an alarm is detected.
Default: OFF
Note:
When "ON" is selected, notification of the alarm
occurrence will be provided to the registered desti-
nation addresses in order (to IP address 1 first, to IP
address 8 last).
[Destination port]
Select a destination port for the Panasonic alarm proto-
col from the following.
Available port number: 1 - 65535
Default: 1818
[Retry times]
Select a retry time for the Panasonic alarm protocol.
Available retry times: 1 - 30
Default: 2
62
I Panasonic alarm protocol
[Destination IP address]
Enter the destination IP address of the Panasonic alarm
protocol from the following. Host name is unavailable for
the destination IP address. Up to 8 destination address-
es can be registered.
To provide notification at an alarm occurrence to the
desired IP address using Panasonic alarm protocol,
check the "Alarm" checkbox respective to the desired IP
address.
To provide notification using Panasonic alarm protocol
when any of the following has occurred, check the
"Diag." checkbox respective to the desired address.
• When notification of the remaining space of the SD
memory card has been provided ( page 27)
• When the SD memory card has become full
• When mounting of the SD memory card has failed
To delete the registered IP address, click the [DEL] but-
ton respective to the desired IP address.
Important:
Confirm that the destination IP addresses are regis-
tered correctly. When a registered IP address does
not exist, notification may be delayed.