Subscribe to Our Youtube Channel
Related Manuals for Mac Afric SPLANE-001
Summary of Contents for Mac Afric SPLANE-001
- Page 1 www.adendorff.co.za Read through carefully and understand these instructions before use...
-
Page 2: Electrical Safety
outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric GENERAL POWER TOOL SAFETY WARNINGS shock. 9. If operating a power in a damp location is unavoidable, use a residual current (For All Power Tools) device (RCD) protected supply. -
Page 3: Specifications
application. The correct power tool will do the job better and safer at the rate SPECIFICATIONS for which it was designed. 18. Do not use tool if switch does not turn it on or off. Any power tool that Rated Power Input 840 W cannot be controlled with the switch is dangerous and must be repaired. -
Page 4: Removing Or Installing Planer Blades
wood. Clean out chips with a stick. Removing or Installing Planer Blades 12. Do not leave the tool running. Operate the tool only when hand-held. 13. When leaving the planer, switch off and set it with the front base up on a CAUTION: ... -
Page 5: Planing Operation
forward. (Fig. 5)Apply pressure on the Blade edge is parallel to the Correct Setting front of the tool at the start of planning rear planer base plate surface while apply pressure on the back when planning the end of the workpiece. (Fig. 6) One or both blades fails to have edge parallel to the For rough cutting, the depth of cut can be... - Page 6 To make a stepped cut as shown in Sharpening Planer Blades Fig. 10, use the edge fence (guide rule). Always keep your blades sharp for the best performance. Remove the planer blade and install it on the sharpening holder to make sure the both blades can be sharpened evenly.
-
Page 7: Maintenance
Always check the blade gauge and Both carbon brushes should be replaced make sure it is not distorted before at the same time. Use only identical setting operation. carbon brushes. (Fig. 18) To set the blade, press the blade edge on the surface A of theguage first. -
Page 8: Explanation Of General View
EXPLANATION OF GENERAL VIEW Hex Flange Head Bolt Baffle Plate Blade Drum Pan Head Tapping Screw Pan Head Screw (with Flat Strain Relief Washer) Blade Shaft Nameplate Planer Blade Cord Guard Adjusting Plate Cord Ball Bearing Compression Spring Washer Washer Front Base plate(Adjustable) Ball Bearing Rear Base Plate (Fixed)
Need help?
Do you have a question about the SPLANE-001 and is the answer not in the manual?
Questions and answers
Wiring of the on and off switch