Panasonic OmniVision PV-DF2036M Operating Instructions Manual page 28

Zero Search
To quickly return to a specific tape counter location.
1
Press DISPLAY during playback to display the
Counter.
2
Press COUNTER RESET at the desired position to
reset to "0:00:00."
3
Continue to record, playback, etc.
4
Press STOP.
5
Press CM/ZERO in Stop mode to start ZERO
SEARCH.
• Unit will go into FF or REW mode and stop at the last point the
Counter was set to 0:00:00.
Audio Mode for Playback
Choose the type of sound track for playback.
1
See the "Playback a Tape" section on page 27 to
playback the tape.
2
Press AUDIO repeatedly (each press within 5
seconds) to select desired mode.
• Select "HIFI (L/R)," to listen to a regular Hi Fi Stereo recording.
Select "HIFI (L)" or "HIFI (R)" to listen only to the left or right channel
of a stereo recording. This is commonly used for Karaoke, music on
one channel and vocals on the other. Select "NORMAL" for linear
stereo playback from a recorded tape with Hi Fi disabled.
• This screen appears when you press AUDIO during playback.
28
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo
Index Search
Search System is ...
Each time a recording is made, an invisible index mark is placed
on the tape. When timer recordings are made, program index
and information are also included. These index marks can be
used to access or scan recordings.
Go directly to the desired recording.
1
PLAY 12:00PM
Press SEARCH in Playback or Stop mode to display
0:00:00
SLP
INDEX SEARCH screen, and then press NUMBER
keys to select the recording number.
2
Press FF or REW to start search.
3
Play begins at search end. To search forward or
back 1 index, press FF or REW while screen below
is displayed (10 seconds).
To cancel,
press STOP.
HIFI(L/R)
HIFI(L)
HIFI(R)
NORMAL
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
1 2 3 4 5
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
1 2 3 4 5
NOTE: ↓ indicates start points of each recording.
Note:
• If Index Search is started very close to an index mark, that index
mark may not be counted in the search.
INDEX SEARCH
ENTER INDEX NUMBER :1
USING 1-9 KEYS
FORWARD SEARCH :FF
REVERSE SEARCH :REW
EXIT :SEARCH
6 7
6 7
INDEX SEARCH
FORWARD SEARCH :FF
REVERSE SEARCH :REW