Toro 31997 Installation Instructions Manual

LED Work Light Kit
Groundsmaster
Model No. 31997
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Preparing for Installation
No Parts Required
Procedure
Note:
Retain all removed parts for later installation
unless otherwise noted.
1. Park the machine on a level surface, lower the
attachment, shut off the engine, engage the
parking brake, and remove the key.
2. Disconnect the negative (-) battery cable
from the battery; refer to the electrical system
maintenance section of the traction unit
Operator's Manual.
© 2022—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® 3200 or 3300 Series Traction Unit with ROPS
Description
No parts required
Light mount
U-bolt
Locknut (3/8 inch)
Flange-head bolt (5/16 x 1 inch)
Flange Locknut (5/16 inch)
Work light assembly
Switch bracket
Switch
Hole plug
Long cable tie
Short cable tie
Work light harness
Register at www.Toro.com.
Form No. 3436-611 Rev B
Installation Instructions
Qty.
–
Prepare for installation.
2
6
12
4
4 Install the work lights and the switch.
4
1
1
1
6
2
Connect the wire harness.
1
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Use
*3436-611*