All service/repair work must be carried out by qualified personnel only Power Cord Replacement • If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard 3 XM - Operator Manual 170728...
Run several cycles, ensure that operator has read and understands instructions Troubleshooting Installation • If machine doesn’t fill after switching on power, check & ensure that hot water supply tap is open, water supply pressure is not below specification 4 XM - Operator Manual 170728...
Page 6
Suggested Best Practice Pre-rinse Scrape and/or rinse plates & glasses in cool water Chemical Use good quality non foaming commercial detergent and drying agent. Do not use domestic detergent which will cause the machine to foam 6 XM - Operator Manual 170728...
Page 12
In line with policy to continually develop and improve its products, Washtech Ltd reserves the right to change specifications and design without prior notice. an Ali Group Company...
Need help?
Do you have a question about the XM and is the answer not in the manual?
Questions and answers