Advertisement

XL
Operator Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the XL and is the answer not in the manual?

Questions and answers

Summary of Contents for Washtech XL

  • Page 1 Operator Manual...
  • Page 2: Table Of Contents

    WARNING Before installation and commissioning, you must read the safety instructions and warnings carefully and all the warning labels attached to the equipment. IMPORTANT Failure to comply (even partially) with the instructions given in this manual will invalidate the product warranty and relieves the manufacturer of any responsibility IMPORTANT The alteration of machine operation, design or the replacement of parts not approved by the manufacturer may void warranties and approvals.
  • Page 3: Safety Instructions

    Safety Instructions WARNING Equipment contains dangerous voltages and can be hazardous if installed or operated incorrectly. non-compliance with warnings or failure to follow the instructions contained in this manual can result in loss of life, severe personal injury or serious damage to property.
  • Page 4 Installation Checklist WARNING Installer must be suitably qualified and ensure compliance with all codes and standards including AS/NZS3500.1. Unpack • Unpack the machine, check for damage and complete delivery. Positioning • Place machine on sound waterproof self draining floor, fit feet and adjust feet to level •...
  • Page 5: Installation Diagram

    XL Installation Diagram XL INST 12-07-17 3 D 5 XP - Operator Manual 170728...
  • Page 6 Operating Instructions Start • Ensure the Upstand (6), wash pump filter (7), and Selector Switch Scrap Trays (5) are in place and shut the door • Turn wall power switch on and select any cycle (1, 2, or 3) • Power light glows red and machine fills automatically Power On Light Cycle Light...
  • Page 7: Troubleshooting

    Troubleshooting Fault Cause Remedy Filling Not filling Water supply valve shut Check Water supply valve Door Switch not operating Check Door is closed Filling during wash cycle Upstand not fitted properly Check Drain upstand is fitted Heating Dishes not hot enough Machine not rinsing Check water supply temperature...
  • Page 8: Xl-2 Schematic Diagram

    XL-2 Schematic Diagram 010177 09/05/17 1 A 8 XP - Operator Manual 170728...
  • Page 9: Accessories

    Accessories 9 XP - Operator Manual 170728...
  • Page 10 Notes 10 XP - Operator Manual 170728...
  • Page 11 Notes 11 XP - Operator Manual 170728...
  • Page 12 In line with policy to continually develop and improve its products, Washtech Ltd reserves the right to change specifications and design without prior notice. an Ali Group Company...

This manual is also suitable for:

Xl-2

Table of Contents