BE Power Equipment PIN HE024 Owner's Manual

BE Power Equipment PIN HE024 Owner's Manual

Industrial fan heater

Advertisement

POWER EQUIPMENT
OWNER'S MANUAL
INDUSTRIAL FAN HEATERS
Model No.: PIN HE024
ASSEMBLY & OPERATION INSTRUCTIONS
V1.0 2024

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PIN HE024 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BE Power Equipment PIN HE024

  • Page 1 POWER EQUIPMENT OWNER’S MANUAL INDUSTRIAL FAN HEATERS Model No.: PIN HE024 ASSEMBLY & OPERATION INSTRUCTIONS V1.0 2024...
  • Page 2: Technical Specifications

    PIN HE024 OWNER’S MANUAL POWER EQUIPMENT POWER EQUIPMENT WARNING 1.1 This appliance should always be used under adult supervision. WARNING: To avoid overheating, do not cover the heater. 1.3 CAUTION-some parts of this product can become extremely hot and cause burns.
  • Page 3: Description Of Control Panel

    PIN HE024 OWNER’S MANUAL POWER EQUIPMENT POWER EQUIPMENT 4. DESCRIPTION OF CONTROL PANEL 4.1 Left Knob: selector with heat setting. 4.2 Right Knob: Thermostat dial 5. SPECIAL SAFETY REGULATIONS 5.1 Before use, please check the marking on the power cord. Depending on the power cord type this appliance may be used in different ambient conditions.
  • Page 4 PIN HE024 OWNER’S MANUAL POWER EQUIPMENT POWER EQUIPMENT 5.2.6 The fan heater must not be placed in rooms where flammable liquids or gases are used or stored. 5.2.7 If an extension cord is used, it must be as short as possible and always be fully extended.
  • Page 5: Using Instructions

    PIN HE024 OWNER’S MANUAL POWER EQUIPMENT POWER EQUIPMENT 6. USING INSTRUCTIONS 6.1 Position the fan heater so that it stands upright on a firm surface and at a safe distance from wet environments and flammable objects. 6.2 Connect the fan heater to the mains.
  • Page 6: Troubleshooting

    PIN HE024 OWNER’S MANUAL POWER EQUIPMENT POWER EQUIPMENT 8. TROUBLE SHOOTING: You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service center.
  • Page 7: Contact Details

    Distributed in Australia by CONTACT DETAILS B.A.R Group P/L 15 Hudson Place, Mulgrave, NSW, Australia 2756 Phone: 02 4577 2144 www.bargroup.com.au Distributed in New Zealand by AIR COMPRESSOR OPERATORS MANUAL CONTACT DETAILS BE Pressure Supply 541D Te Rapa Road, Te Rapa, Hamilton 3200, New Zealand Phone: 07 849 0000 www.bepressure.co.nz...

Table of Contents