Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SANUSLIFE ECAIA ionizer S
Summary of Contents for SANUSLIFE ECAIA ionizer S
- Page 1 EN User Manual Full version User Manual ionizer S ionizer S+ Water Treatment Device International sales through: SANUSLIFE INTERNATIONAL GmbH Via Luigi Negrelli 13/C, 39100 Bolzano (I) Tel.: +39 0471 979998 www.sanusproducts.com – support@sanusproducts.com Version 23.12.13...
-
Page 2: Table Of Contents
When should you measure the pH value of the ECAIA water? ........37 Does the ECAIA ionizer S also work with hard water? ..........37 Does the ECAIA ionizer S also work when using a descaling system? ...... 37 What is the ORP value or the redox potential? ............. 37 Can bacteria accumulate in the ECAIA ionizer S and thus contaminate the water? .................... -
Page 3: Ecaia Ionizer S / Ecaia Ionizer S
ECAIA ioniz- er S faucet. The device in this mode is referred to in the user manual as the ECAIA ionizer S+. Accessories for wall mounting... -
Page 4: B Name And Description Of Individual Parts
To connect the control cable of the optional faucet (mounted un- Shows the e-mail address for customer service in Europe: Service contact der the sink) service@sanuslife.com Fuse holder Fuse for overvoltage protection Selection of the ionization power of the alkaline water; alkaline water fl ows... -
Page 5: Installation (Water Inlet Connector And Device Configuration)
The tap water supply hose (A-6) must be inserted at least 1 cm into the quick release opening. The ECAIA ionizer S can be connected to any water tap using the diverter valve (A-9), provid- ed that the water tap has a compatible standard thread (internal thread M24, external thread M22). -
Page 6: Permanent Connection To The Angle Valve (Appliance In Above-Counter Position)
The ECAIA ionizer S can also be attached to the angle valve (3/8") under the sink. If the device (B-11) on the bottom of the is placed above the working surface, the tap water supply hose (A-6) must go through a hole ECAIA ionizer S and fi... -
Page 7: Permanent Connection To The Angle Valve (Ecaia Ionizer S+; Appliance In Below-Counter Position; Using The Additional Ecaia Ionizer S Faucet)
ECAIA ionizer S wall mounting The ECAIA ionizer S can be placed standing or mounted to the wall. Wall mounting is very easy and the ECAIA ionizer S can thus be positioned in any kitchen, next to or behind the sink, to save space. -
Page 8: Before Use
Either via the volume control (B-10) or via the submenu. 1. Plug the power cable of the ECAIA Ionizer S into the socket. The device requires 230V (US Note: Unfortunately, only setting option B is available for the models of the first production model 120V). -
Page 9: Flow Rate Confi Guration
fl ow rate regulator (B-3) on the device is used to adjust the water pressure. Com- pletely open the cold water faucet and position the switch-over lever of the diverter valve (A-9) so that the water fl ows into the ECAIA ionizer S. Afterwards turn the water 2. Acidic water (B-25), but- fl... -
Page 10: Control Of The Ionization Performance
2-3 days, as new The ECAIA ionizer S has a total of 28 alkaline and acidic levels, which can be controlled by con- fi lters can infl uence the measured values. -
Page 11: Lower Water Outlet (B-12) Confi Guration
If you want to set the ionization The above settings can also be configured using the control buttons of the ECAIA ionizer S performance to a higher level, faucet. To set the alkaline levels, press the ALK button (D2); for the acidic levels, press the ACID press the “alkaline level 1”... -
Page 12: Ecaia Water Production
26). Since the ECAIA ionizer S has no solenoid valves, fi ltered water can also be produced in If necessary, set the ionization performance - as described under point “1.14 - Setting ioniza- the event of a power shortage (this does not apply to the ECAIA ionizer S+ variant, where a so- tion performance”. -
Page 13: Proper Use Of Ecaia Water
(B-19) and the fi lter replacement is indicated. you want to fi ll up ECAIA water for transport, a glass bottle is the best option. SANUSLIFE IN- Filter No. 2 has a maximum fl ow capacity of 3,600 liters of water. -
Page 14: Filter Replacement
If the ECAIA ionizer S is not used for a period of more than 2 months, we recommend you clean CAUTION: If water runs off inside the device, the device must it as described under point “4.3 Cleaning and disinfection”... -
Page 15: Maintenance And Care
To enjoy your ECAIA ionizer S for a long time, it is important that you handle, maintain and care In order for the ECAIA ionizer S to perform at its best, it is necessary that the device is regularly for your device carefully and properly. In this context, you should always observe the following: descaled. - Page 16 fi tting of the ECAIA ionizer S faucet open into the container. To be able to connect the desca- on the propeller wheel. The wheel should then spin again.
-
Page 17: Cleaning And Disinfection
• fecting food. wise malfunctions or damage may be caused. Should a malfunction occur, pull out the power SANUSLIFE INTERNATIONAL recommends the use of ECAIA+ allhygienics, available in the plug immediately and discontinue the use of the device. SANUSSTORE. •... -
Page 18: Error And Problem Handling
Error and problem handling Do not lift the device by the fi lter cover. The fi lter cover could come off and the device could • fall and / or break. Only lift the device by the bottom. Check the options below to resolve possible problem or errors. If this is ineffective, please contact Never tilt the device forwards, backwards or to the side when in use. -
Page 19: Faqs
Does the ECAIA ionizer S also work with hard water? Yes. The ECAIA ionizer S also works with hard water. The ionization performance can be set in- dividually and adapted to the respective water hardness. Does the ECAIA ionizer S also work when using a descaling system? Yes. -
Page 20: Can Bacteria Accumulate In The Ecaia Ionizer S And Thus Contaminate The Water
This following is the specialty of the ECAIA ionizer S: While conventional fi lter systems often fi lter out too little, others fi lter out ”everything”, turning it into distilled or osmosis water, the ECAIA ionizer S only fi lters the pollutants. -
Page 21: Technical Specifications
Water pressure 0.7 - 6.0 bar sure you that you have made an excellent choice. The ECAIA ionizer S was made from the highest quality materials. Therefore, you can rest assured that with the ECAIA ioniz- er S you have a top-quality device and you will enjoy it for a long time if used proper- Allowed temperature 5 - 25°C... -
Page 22: Product Information
Warranty and guarantee do not extend to the calcifi cation of the device. A descaling set is sent free of charge when you order the ECAIA ionizer S. The exact description and the recommended frequency of the descaling process is described in detail under point ”4.2 Descaling”. The warran-... -
Page 23: Certificates
Important Note: We assume no liability for accessories that are not listed! Packaging and shipping: It is best to pack the product in the original box and send it in a sturdy, standard packaging box. SANUSLIFE INTERNATIONAL assumes no liability for shipping damage. - Page 24 Water Treatment Device International sales through: SANUSLIFE INTERNATIONAL GmbH Via Luigi Negrelli 13/C, 39100 Bolzano (I) Tel.: +39 0471 979998 www.sanusproducts.com – support@sanusproducts.com...
Need help?
Do you have a question about the ECAIA ionizer S and is the answer not in the manual?
Questions and answers