MODEL CMOTTK30 CONVECTION MICROWAVE TRIM KIT INSTALLATION INSTRUCTIONS Before you begin, read these instructions completely and carefully. Getting Started ■ Remove packaging Contents Part Description Trim Assembly Base Rear Duct Forward Duct Foam Tape Mounting Bracket (L/R) Sheet Metal Screws Before installing trim kit, install the convection duct as follows: 1.
Page 2
Installing Trim Kit 1. Cut opening in the cabinet face per the following dimensions: Height: 19-3/16” + 1/16”, –0 Width: 25-3/4” + 1/16”, –0 Note: Refer to diagram on the following page. The minimum cabinet depth is 20”. When installing the Microwave and Trim Kit in combination with a Wall Oven or Warming Drawer, please follow the recommendations in the Microwave Installation/ Use &...
FOAM TAPE ON THIS FLANGE FORWARD CONVECTION DUCT SCREW HOLE MOUNTING BRACKET SUPPORT INSERT 4 TRIM KIT ASSEMBLY BOTTOM PIN OF TRIM INSERT 3 Stainless Steel Care This Trim Kit is made of stainless steel. Use the mildest cleaning procedure first. Start with hot soapy water, rinse and dry.
Page 4
5800 Skylab Road, Huntington Beach, CA 92647 Tel: 714.372.7000 • Fax: 714.372.7001 Customer Service: 888.281.5698 P/N 241185 Rev. A 10/07 www.dcsappliances.com...