Table of Contents
Related Manuals for ROSSO MOTORS COBRA
Summary of Contents for ROSSO MOTORS COBRA
- Page 1 ROSSO COBRA ELECTRIC SCOOTER OWNERS MANUAL PRIOR TO FIRST USE, READ THIS MANUAL COMPLETELY AND ATTENTIVELY! IMPERATIVELY FOLLOW THE SAFETY INSTRUCTIONS! NONOBSERVANCE CAN LEAD TO PERILOUS INJURIES! CAREFULLY KEEP THIS MANUAL!
-
Page 3: Table Of Contents
PLEASE INSPECT THE COBRA UPON ARRIVAL AND REPORT ANY DAMAGES THAT MAY HAVE OCCURRED DURING SHIPPING ⚠ SAFETY WARNING ⚠ Riding an electric scooter can be dangerous. Like other electric products, electric scooters can and are intended to move, and it is therefore possible to lose control, fall off and/or get into dangerous situations that no amount of care, instruction or expertise can eliminate. -
Page 4: Safety Information
SAFETY INFORMATION ALWAYS follow safety information, product instructions and recommended maintenance and care, to ensure the best possible performance, lifespan and experience with a new scooter! ALWAYS check and obey any local laws or regulations that may affect the locations where the eBike may be used. -
Page 5: Assembly
ASSEMBLY The Rosso Cobra requires minimal assembly. Please follow the instructions below in order to get your scooter assembled properly. We recommend saving all packaging materials until the scooter is completely assembled to avoid accidentally discarding any misplaced small components. Please ensure the components below are included within your scooter’s boxes. - Page 6 ASSEMBLY continued… 2 - Handlebars Begin by unfolding the scooter by pressing down on the folding lever with one hand while gently pulling up on the steering column with the other. Fully extend to the upright position until the locking mechanism clicks into place.
- Page 7 Complete the handlebar setup by adjusting the brake levers. Loosen the hex bolts and shift the levers to a comfortable position and retighten the bolts. Be careful not to pull on the wire while securing the handlebars and brake levers 3 - Fuse Release the locking tabs on the under both edges of the footboard and lift it as shown.
-
Page 8: Component Diagram
Ensure the silver locking clamp is in place at the top of the seat post as shown. Pull out the upper portion of the seat post to the desired height and tighten the lock clamp securely. Attach the seat to the upper seat post and tighten the seat bolts securely. -
Page 9: Operating The Scooter
Rear brake lever, throttle, battery gauge Footboard, battery (internal) Front brake lever, light switch Head unit, front shock Ignition switch Front wheel, front brakes Headlight Kickstand (left), charging port (right) Seat Rear shocks, motor Seat post Rear fender Folding lever Rear wheel, rear brakes OPERATING THE SCOOTER Powering ON/OFF... - Page 10 To start the scooter, first ensure the kickstand is in the upright position, then insert the key into the ignition and turn to the ON position. Turn the key to the OFF position and remove to turn the scooter off. If the scooter is turned on for more than 10-15 minutes without moving, an automatic power saving feature activates and the scooter will shut itself off.
-
Page 11: Maintenance & Care
CAREFUL TO NOT BE HIT BY THE COLLAPSING HANDLEBARS. ⚠ MAINTENANCE AND CARE Proper care of this Cobra scooter will ensure optimal performance and longer life. Maintenance Checklist: Clean you scooter with a soft damp cloth (do not spray with water) - Page 12 Chargers may become warm or emit sound during regular use, this is a normal response and is no cause for concern. Oppositely if it does not do either that does not indicate it is not working properly. If the charger becomes very hot, please unplug it and contact Rosso Motors technical support. Adjustments The scooter comes fully adjusted from the factory and should be ready to ride once assembled and charged.
- Page 13 Brakes NOTE: Brakes may squeak before they are broken in. This is normal and will not affect the function or performance of the brakes. With continued use the squeak should go away. To adjust the brakes begin with minor changes by turning the tension adjuster on the left(front) or right(rear) handlebar.
-
Page 14: Troubleshooting
To get the longest possible life out of your chain, it must be well properly tensioned and aligned onto the sprockets in order to avoid uneven wear. Signs of an improperly tensioned chain: ● The chain is skipping/jumping on the sprocket, or has fallen off completely, due to being too loose. -
Page 15: Warranty Information
Symptom Possible Cause Solution Charger light turns Battery is fully charged Check battery gauge green & red right away. Bad Fuse or open Check Fuse, look for loose or connection disconnected wires between charger socket and batteries Damaged or faulty battery Replace battery Batteries do not Battery is damaged, faulty, or... - Page 16 WARRANTY ROSSO MOTORS warranties this product to be free of manufacturing defects for a period of 6 months from the date of purchase. This limited warranty does not cover normal wear and tear components, (tires, tubes, brake cables, etc) or any damage, failure or loss caused by improper assembly, maintenance, care, storage or use of the Rosso Cobra Scooter.
- Page 17 11400 Twigg Place Unit 1 Richmond, BC, V6V3C1 CANADA hello@rossomotors.com www.rossomotors.ca 1-888-897-5909 © Rosso Motors, 2024. All Rights Reserved...
Need help?
Do you have a question about the COBRA and is the answer not in the manual?
Questions and answers