Subscribe to Our Youtube Channel
Related Manuals for ROSSO MOTORS COBRA
Summary of Contents for ROSSO MOTORS COBRA
- Page 1 ROSSO COBRA ELECTRIC FOLDING KICKSTAND SCOOTER OWNERS MANUAL - PRIOR TO FIRST USE, READ THIS MANUAL COMPLETELY AND ATTENTIVELY! IMPERATIVELY FOLLOW THE SAFETY INSTRUCTIONS! NONOBSERVANCE CAN LEAD TO PERILOUS INJURIES! CAREFULLY KEEP THIS MANUAL!
-
Page 2: Table Of Contents
PLEASE INSPECT YOUR COBRA UPON ARRIVAL AND REPORT ANY DAMAGES THAT MAY HAVE OCCURRED DURING SHIPPING ⚠ WARNING: Riding an electric scooter can be dangerous. Like other electric products, electric scooters can and are intended to move, and it is therefore possible to lose control, fall off and/or get into dangerous situations that no amount of care, instruction or expertise can eliminate. -
Page 3: Safety Guide
SAFETY GUIDE The recommended minimum age for riding this scooter is 8 years old. NEVER allow children to operate the scooter without adult supervision. This scooter is designed for 1 person only with a recommended weight limit of 200lbs (90kg). To avoid damage to the motor and footboard, do not overload the scooter. -
Page 4: Assembly
ASSEMBLY Your Rosso Cobra requires minimum assembly. Please follow the instructions below in order to get your scooter assembled properly. We recommend thoroughly checking saving shipping packaging until the scooter is completed to avoid accidentally disposing of hardware or components. - Page 5 1 - Front Wheel Carefully remove the scooter from the box. To install the wheel, remove the axle nut then move the wheel into place with the brake disc slotted in between the brake pads of the caliper. Replace the bolt, adding spacers on either side of the wheel, then secure the axle nut back into place.
- Page 6 Adjust the silver clamp at the top of the handlebar post. Be sure to orient the bars in the correct riding position with the throttle on the rider’s right side. Remove the nut from the front bolt, slip the headlight bracket over the bolt and replace the nut.
- Page 7 Attach the seat to the upper seat post and tighten the seat bolts securely. Your Cobra scooter should now be fully assembled. Your Cobra does not come fully charged and it is recommended to do so before your first use.
-
Page 8: Scooter Components
SCOOTER COMPONENTS Rear brake lever, Footboard, throttle, battery gauge battery (internal) Front brake lever, light Head unit, front shock switch Ignition switch Front wheel, front brakes Headlight Kickstand (left), charging port (right) Seat Rear shocks, motor Seat post Rear fender Folding handle Rear wheel, rear brakes... -
Page 9: Operating Your Scooter
OPERATING YOUR SCOOTER Charging your scooter Your scooter comes with minimal charge to preserve battery life. We recommend fully charging your scooter prior to its first use, after each use and prior to storage. NOTE: Always follow recommended battery care (pg #11) and do not allow the battery to completely discharge, this may damage the battery To charge, first, make sure your scooter is turned off. - Page 10 To start the scooter, first ensure the kickstand is in the upright position, then insert the key into the ignition and turn to the “ON” position. Put one foot on the deck of the scooter while pushing off with the other foot, gently rotate the THROTTLE GRIP, on the right handlebar.
-
Page 11: Maintenance & Care
MAINTENANCE & CARE Proper care of your scooter will ensure optimal performance and longer life. Maintenance Checklist: Clean you scooter with a soft damp cloth (do not spray with water) Visually inspect the scooter for damages (bent parts, frayed wires, etc) Check Tire pressure (30-36PSI) Ensure Brakes functioning properly Check fasteners for tightness... - Page 12 Adjustments Your scooter comes fully adjusted from the factory and should be ready to ride once assembled and charged. Inspection prior to first use and periodically is recommended however as adjustments may need to be made due to shifting/vibration during shipping and from normal usage. Brakes NOTE: Brakes may squeak before they are broken in.
- Page 13 Front Brakes For brakes that are too loose, adjust the tension screw on the left hand brake lever by rotating it counter-clockwise until the wheel spins freely. For brakes that are too tight, adjust the tension screw on the left hand brake lever by rotating it clockwise until the wheel has a slight drag.
- Page 14 Chain To get the longest possible life out of your chain, it must be well properly tensioned and aligned onto the sprockets in order to avoid uneven wear. Signs of an improperly tensioned chain: ● The chain is skipping/jumping on the sprocket, or has fallen off completely, due to being too loose.
-
Page 15: Troubleshooting
Troubleshooting This following is a list of basic occurrences and some possible solutions, for more complex problems or if you need any further assistance, please contact us directly via email at: hello@rossomotors.com Symptom Possible Cause Solution Charger light turns Battery is fully charged Check battery gauge green &... - Page 16 6 months from date of purchase. This Limited Warranty does not cover normal wear and tear, (tires, tubes or cables) or any damage, failure or loss caused by improper assembly, maintenance, storage or use of your Cobra eScooter.
- Page 17 11400 Twigg Place Unit 1 Richmond, BC, V6V3C1 CANADA E-Mail: hello@rossomotors.com Website: www.rossomotors.com Tel: 1-888-897-5909 © Rosso Motors, 2022. All Rights Reserved...
Need help?
Do you have a question about the COBRA and is the answer not in the manual?
Questions and answers