Advertisement
Welcome to minicom 2.7.1
OPTIONS: I18n
Compiled on Aug 13 2017, 15:25:34.
Port /dev/ttyUSB2
Press CTRL-A Z for help on special keys
AT
OK
Step 3. Networking Setup with AT Commands
AT+QCFG="usbnet",1
AT+CGDCONT=1,"IPV4V6","YOUR_APN"
AT+CFUN=1,1
Wait for the modem to boot again. It may take 30 seconds. Once the modem reboots, the
minicom will be activated again.
After the reboot, open a new Linux terminal and check for usbX in the network interface
using ifconfig or ipaddr commands.
After rebooting the module, the NET indicator is on, and you can use the following
commands to check the network. (Optional)
Advertisement
Need help?
Do you have a question about the SIM8202G-M2 and is the answer not in the manual?
Questions and answers