Doss SoundBox XL Ultra Quick Start Manual page 3

8. Use your speaker with Echo Dot
You can connect the Dot with the speaker by Bluetooth.
Please follow the steps to set up via Bluetooth:
1. Download the Alexa app and follow the standard setup procedure to get the
dot connected to your home Wi-Fi network.
2. Switch the SoundBox XL Ultra to Bluetooth mode.
3. Run the Alexa App, tap Menu, and then tap Se�ngs.
4. Tap the Echo Dot in your list of Alexa devices, then tap Bluetooth.
5. The SoundBox XL Ultra should appear in the list of Bluetooth devices. If not,
please long press the Bluetooth bu�on and try it again.
6. Once listed, tap on the speaker to complete the pairing process.
7. To remove the device, return to Bluetooth > tap the name of speaker > tap
"Forget Device"
Note:
Voice command will not be able to turn on/off the speaker if you connect to it via Bluetooth.
9. Safety instruc�ons
• Avoid dropping or hi�ng the speaker.
• Avoid exposing to extreme temperature.
• Avoid using the speaker near a microwave.
• Never disassemble or repair the speaker.
• Never use any corrosive cleanser/oil to clean.
• Never leave the speaker in a car parked in the sun.
• Never a�empt to charge the speaker while it is wet.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protec�on against harmful interference in a residen�al
installa�on. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruc�ons, may
cause harmful interference to radio communica�ons. However, there is no
guarantee that interference will not occur in a par�cular installa�on. If this
equipment does cause harmful interference to radio or television recep�on,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separa�on between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Cau�on: Any changes or modifica�ons to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.This device
complies with part 15 of the FCC Rules. Opera�on is subject to the following
two condi�ons:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired opera�on.
RF Exposure Informa�on
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condi�on without restric�on.
ISED Statement
This device contains licence-exempt transmi�er(s)/receiver(s) that comply with
Innova�on, Science and Economic Development Canada's licence-exempt
RSS(s). Opera�on is subject to the following two condi�ons:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may
cause undesired opera�on of the device.
This equipment should be installed and operated with a minumum distance of
20 cm between the radiator and your body.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
auxappareils radio exempts de licence. L'exploita�on est autorisée aux deux
condi�ons suivantes : (1)l'appareil ne doit pas produire de brouillage, et (2)
l'u�lisateur de l'appareil doit accepter toutbrouillage radioélectrique subi,
même si le brouillage est suscep�ble d'en comprome�re lefonc�onnement.
CAN ICES-3(B)/NMB-3(B)
L'appareil a été évalué pour répondre aux exigences générales d'exposi�on aux
RF. Le disposi�f peut être u�lisé sans restric�on dans des condi�ons porta�ves
d'exposi�on.
Cet équipement doit être installé et u�lisé à une distance minimale de 20 cm
entre le radiateur et votre corps