F&F SCO-802 Quick Start Manual

SCO-802
Lighting dimmer with
„memory" of light
intensity settings
Do not dispose of this device in the trash along with other waste!
According to the Law on Waste, electro coming from households free of charge and can
give any amount to up to that end point of collec� on, as well as to store the occasion of
the purchase of new equipment (in accordance with the principle of old-for-new, regard-
less of brand). Electro thrown in the trash or abandoned in nature, pose a threat to the
environment and human health.
Purpose
The SCO-802 lighting dimmer is used for switching on and off
incandescent and halogen lighting with the ability to adjust in-
tensity using any momentary (bell) switch.
Functioning
The lighting is switched on after a current pulse caused by pres-
sing the momentary (bell) button connected to the dimmer. The
lighting will be switched off after the next pulse. Lighting can be
controlled with multiple buttons connected in parallel and pla-
ced at different points in the room. By holding the button down
for more than 1 second, you can set the desired illumination in-
tensity in one direction from the current setting to the maximum
or minimum. The direction of change (brightening or dimming) is
forced by the dimmer and always changes to the opposite after
each setting.
F&F Filipowski sp.j.
Konstantynowska 79/81, 95-200 Pabianice, POLAND
phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71
www.fif.com.pl; e-mail: biuro@fif.com.pl
- 1 -