ALAVENTE CEETCB-0059 Installation Instructions

Part List:
◆ 1 * Front Crossbar (Longer)
◆ 1 * Rear Crossbar (Shorter)
◆ 4 * Clamp Bracket
◆ 1 * Hexagon Wrench
◆ 1 * Lever Key
Tools Required:
•Trim Tool
Note:
Check your vehicle's owner's manual
for the maximum roof load capacity and
be careful not to damage the roof paint.
Observe speed and height limits when
driving.
Observe weight limits when loading.
Verify the direction of mounting
support and gaskets before installation.
Note the "L/R mark underneath
mounting support.
Operator Safety：Use caution to avoid
risk of injury.
INSTALLATION INSTRUCTIONS
1. Clean the roof before installing the roof rack.
2. Verify that the clip is correct by looking at the
position markings on the top of the clip before
installation.
3. Open the key cover on the mounting bracket.
A: Insert the lever key and turn to unlock the
lock cover, and remove the clamp foot support
cover;
B: Remove the lower part of the clip foot.
4.Before installation, please confirm the
installation direction of the rails of the roof rack
and the front and rear cross bars.
5.Assemble the front and rear roof racks:
Insert the crossbar into the mounting bracket and
fasten it with bolts.
6. Place the front and rear roof racks on the roof
rails.
7. Install the clip foot bracket on the roof rack,
and verify whether the clip is correct before
installation
Look for the position marker clip on it.
8. Make sure the lever screw is engaged and the
bottom bracket is flush with the upper bracket,
tighten the lever handle.
INSTALLATION INSTRUCTION
9. After the pull rod is tightened, step back a
circle, use the opening on the bracket to pry up
the pull wire, and close the pull rod.
10. Use the key provided to turn the locking
lever to lock the crossbar in place.
11. After installing the roof racks, shake each
rack to make sure the rails are securely fastened
to the side rails.