Table of Contents
Advertisement
5. After the hardware installation is completed, restart the system and install the NV
SLI driver/utility. A configuration panel will be provided for Multi-GPU control. Check
the Enable multi-GPU box to enable the SLI function for the onboard graphics
cards (concerning the details of multi-GPU settings, please refer to your graphics
card manual) .
Check the box
6. Restart your system and a pop-up message will show in the system tray confirm-
ing that M ulti-GPU has been enabled.
Important
If you want to remove one graphics card and quit the SLI function, make sure
that you reset the SLI switch card (SLI mode to non-SLI mode) and disable the
"MultiGPU" function.
Hardware Setup
2-25
Hide quick links:
Advertisement
Table of Contents
