Charge mode. Supports Over-Current Protection & Short Circuit Protection on each port. ✔ ✔ For the Over Temperature Protection, if the unit’s high temperature is over the setting, it would cut off all the output current Need help? Visit: coolgear.com/support...
Page 3
This unit does not contain an accessory set of cables for iPad, tablet. Please check with your distributor ● regarding using appropriate cable. LED Indicators LED illuminates Green: Fully charged or devices disconnected ● LED illuminates Red: The port of Charging in progress ● Need help? Visit: coolgear.com/support...
Page 4
1. To install, attach the surface/mounting brackets to the unit’s side panels (one on each side) and secure them with the screws provided. 2. Use the mounting brackets and screws on the rack or surface of choice. Need help? Visit: coolgear.com/support...
Page 5
3. Plug the power adaptor into the wall outlet. 4. Turn on the power switch. 5. Using the USB Type C cable provided and connects one end to the unit. 6. Using the other end, connect to your host computer. Need help? Visit: coolgear.com/support...
Page 6
2~4 hubs. Once the 1st hub is disconnected to the computer, the 2~4 hubs will switch to Charge mode and work on same function. On the contrary; once the 1st Need help? Visit: coolgear.com/support...
Page 7
Please check for updates manually to keep your software up to date. [ For iPad, tablet configuring ] Ensure each iPad, tablet has been charged completely at first if the objective ● iPad, tablet is new goods. Need help? Visit: coolgear.com/support...
Page 8
If user connects with two units, the 2nd unit may not be detected by some ● computers which have built in USB 3.0 hub. 1. Follows the step of connection with host computer, and connects host computer with the 1st unit. Need help? Visit: coolgear.com/support...
Page 9
4. Put the plug of power adaptor into the wall outlet. 5. Turn on the power switch of the 2nd unit. 6. Use the USB Type C cable provided and connects both USB Type C ports of the 1st and 2nd units. Need help? Visit: coolgear.com/support...
Page 10
(iv) normal wear and tear; (v) damage to or loss of repaired or replaced Products during shipping by Coolgear except when such damage or loss is caused by poor or inadequate packaging by Coolgear; or (vi) Products purchased outside the United States.
Need help?
Do you have a question about the USB-12XU1CH and is the answer not in the manual?
Questions and answers