MULTIQUIP TB12-PE Service Manual

Technical
Information
The information and specifications included in this publication were in effect at the time of approval for printing. Illustrations, descriptions, references and technical data
contained in this document are for guidance only and may not be considered as binding. Multiquip Inc. reserves the right to discontinue or change specifications,
design or the information published in this publication at any time without notice and without incurring any obligations.
FRONT AXLE REMOVAL & REPLACEMENT
1
1) Loosen the wheel nuts while the machine is on the floor, but do not
remove at this point. Ref. Fig. 1
2) Take out the gimbal stop pin from its vertical stowed position and replace
in a horizontal position to lock the steering. Ref. Fig. 2
3)
Loosen the handlebar clamp and position handlebars so they are in a
vertical position. Ref. Fig. 3
Fig. 1
4) With the steering locked, lift and tilt the machine onto its back, use
2
cardboard on the floor to prevent damage to the paintwork. Remove the
wheels. Ref. Fig. 4
5) Remove the front bottom skid plate by removing the 10 x M6 bolts. Ref.
Fig. 5
CAUTION: Care must be taken when lifting the machine. Proper manual
handling techniques must be employed when lifting heavy loads. If possible,
use mechanical aids to lift and support loads.
TB12-PE, SE Front Axle Removal & Replacement
Fig. 2
Fig. 4
Product Group:
Model: TB12-PE, SE
Fig. 3
Fig. 5
1 of 4
CONCRETE
4/6/2023