QuanSheng UVK5 User Manual page 5

3.3.普通消息存储区（M0~M4）
3.3. Normal Message Slots (M0~M4)
固件提供5个普通消息存储区，编号从
The firmware provides 5 normal message slots, numbered from
每个存储区提供最多64字符的消息存储。可存储的字符为A~Z,0~9以及空格。无效字符（空内容）显示为 * 号
Each slot can storage of up to
使用
0 FM 9 Call
~
Using
当需要连续输入同一个按键对应的字符时，可通过
When input characters corresponding to the same key, use
注意： 键只对应字符 1 ，
1 Band
Note： only corresponds to "1",
3.3.快速消息存储区（MQ）
3.3. Quick Message Slots (MQ)
固件提供1个快速消息存储区，编号为
The firmware provides 1 quick message slot, number is
快速消息存储区有普通消息存储区的所有功能，你可以在此编辑消息并直接发送
The quick message slot has all the functions of the normal message slots. You can edit messages here and send them directly.
在普通消息存储区（M0~M4）中，可按
In normal msg slots (M0~M4)，pressing
3.4.注意事项
3.4. Attention
消息存储区以 * 号作为无效符号，消息发送和消息拷贝动作都在遇到第一个 * 号时停止。所以请在操作前检查是否存在不必
要的 * 号
The msg slots uses "*" as invalid symbol. Message sending and message copying actions stop when encountering the first "*". Check whether
there are unnecessary "*" in message before operation
消息发送完成（即发送到第一个 * 号）后，发送计数器不会复位，可通过退出编辑器、切换存储区、清空存储区复位发送计数器
After the message is sent (sent to the first "*"), the sending counter will not be reset. You can reset the sending counter by
switching msg slots, or clearing the
到 ，可通过屏幕上的标识判断当前存储区
64 characters. The valid characters are A~Z, 0~9 and space. Invalid characters (empty) are displayed as "*"
输入消息。当按下不同的键时，当前按键的值将被保存，并进入下一个字符。
to enter msg. When a different key is pressed, current char is confirmed and move to the next char.
0 FM
键将MQ中的有效字符粘贴到光标所在位置
M A
to paste valid characters in MQ to cursor position
MQ
slot.
to . Check current slot by the number on the screen.
键确认当前值并进入下一个字符
* Scan
to confirm the current char and move to the next character.
键对应字符 0 与空格
corresponds to 0 and space
M A
M0 M0
exiting Edit Mode,
@Waixinyatian