Table of contents Table of contents General information..........................5 1.1 Symbols and signal words....................... 5 Safety instructions............................. 7 Features................................9 Operation..............................10 Technical specifications........................14 Protecting the environment......................16 LST-250 Lighting Stand...
Please refer to the latest version of the documentation, which is ready for download under www.thomann.de. 1.1 Symbols and signal words In this section you will find an overview of the meaning of symbols and signal words that are used in this document. LST-250 Lighting Stand...
Page 6
NOTICE! This combination of symbol and signal word indicates a pos‐ sible dangerous situation that can result in material and environmental damage if it is not avoided. Warning signs Type of danger Warning – danger zone. LST-250 Lighting Stand...
Risk of injury due to tipping of the stand during loaded transport! If the stand is moved without having removed the installed devices, the stand may tip over and cause injuries and property damage. Remove the installed devices before transporting the stand. LST-250 Lighting Stand...
Page 8
The plasticiser contained in the rubber feet of this product may react with the coating of the floor and cause permanent dark stains after some time. If necessary, use a suitable mat or felt slide to prevent direct contact between the device’s rubber feet and the floor. LST-250 Lighting Stand...
Metal construction with cross-beam for up to four spotlights Extension tubes secured by safety bolt and cotter pin Cross-beam mounting Cross-beam: 1.20 m Maximum weight-bearing capacity: 18 kg Minimum height: 1.25 m Maximum height: 2.60 m Maximum vertical lift: 1.35 m Weight: 6 kg LST-250 Lighting Stand...
Risk of injury due to tipping of stand on an unsuitable ground! When the stand is installed on soft or uneven ground, the stand may tip over and cause injuries and property damage. Install the stand only on even and solid ground. LST-250 Lighting Stand...
Page 11
The plasticiser contained in the rubber feet of this product may react with the coating of the floor and cause permanent dark stains after some time. If necessary, use a suitable mat or felt slide to prevent direct contact between the device’s rubber feet and the floor. LST-250 Lighting Stand...
Page 12
Pull out the lower extension tube to the required height, insert the safety bolt through the appropriate grid holes and slide the safety cotter through the hole in the safety bolt. Fix the position of the lower extension tube with the safety screw on the lower tube clamp. LST-250 Lighting Stand...
Page 13
Loosen the safety screw on the carriage to which the three feet are attached. Fold up the feet of the stand. Pack the individual parts of the system in their original packaging if possible, and store the package in a dry place protected against moisture. LST-250 Lighting Stand...
Holder type Flange, Æ 16 mm, for mini TV spigot (5/8") Load, max. (with centric load) 18 kg Transport dimensions (B × H × T) 125 mm × 1210 mm × 90 mm Weight 5 kg Colour black LST-250 Lighting Stand...
Page 15
Technical specifications Further information Stand type Lighting stand Incl. crossbar Crank LST-250 Lighting Stand...
Do not dispose of these materials with your normal household waste, but make sure that they are collected for recycling. Please follow the instructions and markings on the packaging. Observe the disposal note regarding documentation in France. LST-250 Lighting Stand...
Need help?
Do you have a question about the LST-250 and is the answer not in the manual?
Questions and answers