Kyocera 2345 User Manual page 5

2300 series
Hide thumbs Also See for 2345:
Table of Contents

Advertisement

Resetting the phone
If the screen seems frozen and the keypad does not
respond to keypresses, reset the phone by
completing the following steps:
1. Remove the battery door.
2. Remove and replace the battery.
If the problem persists, return the phone to the
dealer for service.
Qualified service
If you are experiencing problems with your phone,
see "Getting Help" on page 50. If you have
additional questions, contact your service provider
for technical support. If the problem persists, return
the phone with all accessories and packaging to the
dealer for qualified service.
Accessories
Use only Kyocera-approved accessories with
Kyocera phones. Use of any unauthorized
accessories may be dangerous and will invalidate
the phone warranty if said accessories cause
damage or a defect to the phone.
To shop online for a Hands-free Car Kit and other
phone accessories, visit
www.kyocera-wireless.com/store .
To order by phone, call (800) 349-4188 (U.S.A. only)
or (858) 882-1410.
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver.
When it is on, it receives and sends out RF energy.
Your service provider's network controls the power
of the RF signal. This power level can range from
0.006 to 0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure guidelines
with safety levels for hand-held wireless phones.
These guidelines are consistent with the safety
standards previously set by both U.S. and
international standards bodies in the following
reports:
• ANSI C95.1 (American National Standards
Institute, 1992)
• NCRP Report 86 (National Council on Radiation
Protection and Measurements, 1986)
• ICNIRP (International Commission on
Non-Ionizing Radiation Protection, 1996)
Your phone complies with the standards set by these
reports and the FCC guidelines.
E911 Mandates
Where service is available, this handset complies
with the Phase I and Phase II E911 Mandates issued
by the FCC.
Battery and Charger Specifications
Charger
CV90-B1523-1
100-240VAC / 50/60Hz
CV90-60858-1
100-240VAC / 50/60Hz
CV90-B1501-1
100-240VAC / 50/60Hz
CV90-61016-1
100-240VAC / 50/60Hz
CV90-60859-1
120VAC / 60Hz
Standard Battery: 3.6V / 975mAh
093 453 037
Kyocera Wireless Corp.
10300 Campus Point Drive
San Diego, CA 92121 U.S.A.
Visit us at www.kyocera-wireless.com
To purchase accessories, visit
www.kyocera-wireless.com/store
Input
Output
4.4V 1A
4.5V 1.5A
4.4V 1A
4.5V 1.5A
5.2V 400mA

Advertisement

Table of Contents
loading

Table of Contents