Return The Router To Router Mode; Manage Led Blinking Or Turn Off Leds - NETGEAR Nighthawk RS500 User Manual

Return the router to router mode

By default, your router is set to router mode. If you changed the mode to access point
mode (AP mode), you can change the mode back to router mode.
To return the router to router mode:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Router / AP Mode.
The Router / AP Mode page displays.
5. Select the Router Mode radio button.
The page adjusts.
6. Click the Apply button.
The IP address of the router changes, and you are disconnected.
7. To reconnect, close and restart your browser and type http://www.routerlogin.net.
Manage LED blinking or turn off
LEDs
You can disable or enable LED blinking. You can also turn off the LEDs.
NOTE: These instructions are for disabling or enabling LEDs from the router
web interface. You can also press the LED On/Off button on the front of the
router.
To manage LED blinking or turn off the LEDs:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
Manage and Monitor Your
Router
Nighthawk WiFi 7 Tri-Band Router Model RS500
131 User Manual