Page 2
2. Close the water valve and turn off the power to the water heater. 3. Open the hot and cold water at a bathroom faucet to relieve the pressure in the plumbing system. PL-017-SS Rev. A2 072015...
Depends on the depth, choose the one best fit the installation. Leaving about 1” of the con- nector showing outside the wall. (NOTE: Apply some PTFE tape on both end of the connector.) Te on (PTFE) Tape Decor Star...
Page 6
Insert the anchors into the wall. (NOTE: Before installing the wall anchors, use a small piece of painters tape or masking tape over the drill area. This will prevent dam- 1” ages to the tile) PL-017-SS Rev. A2 072015...
Page 7
8. Disassemble the water supply hose assembly by loosen the compression nut (C),remove compression ring (B) and pull out the elbow connetor (A) Decor Star...
Page 8
(NOTE: Do not over tighten the nut as it may damage the seal and causes leaks) Once the connection is made, install the cover (B) over the elbow con- nector. PL-017-SS Rev. A2 072015...
Page 9
Installation (cont.) 12. Connect hand shower to the hose and connect the entire assembly to the shower panel body. Decor Star...
Operation 1. To use your new Decor Star shower panel, first turn on the water supply at the existing valve (B) divert the water to the shower panel. 2. Use the control knob (A) to select the desired shower function.
Need help?
Do you have a question about the PL-017-SS and is the answer not in the manual?
Questions and answers