Table of Contents
Advertisement
Quick Links
USER INSTRUCTIONS
TRIPOD SYSTEM
Complies with ANSI Z359.18-2017 (Type A), ANSI Z359.14-2021 standards and OSHA
29 CFR 1910 and 1926
User Instruction Manual for T700000XR, T100108, T410060, T100008B, and T200007.
WARNING!
Compliant fall protection equipment must only be used as it was designed and adhere to
the hierarchy of controls as discussed in ANSI Z359.2. Users MUST read and follow all user
instructions provided with the product. Before using a fall arrest system, users must be trained
in the safe use of the system, as required by OSHA 29 CFR 1910.30 and 1926.503, or local safety
regulations. Misuse or failure to heed these warnings and instructions may result
in injury or even death.
WORK SAFE! WORK SMART!
IF YOU HAVE ANY QUESTIONS ABOUT THE PROPER USE OF THE EQUIPMENT, SEE YOUR
SUPERVISOR, USER INSTRUCTIONS, OR CONTACT WERNERCO FOR MORE INFORMATION.
Advertisement
Table of Contents
Related Manuals for Werner T700000XR
Summary of Contents for Werner T700000XR
- Page 1 Complies with ANSI Z359.18-2017 (Type A), ANSI Z359.14-2021 standards and OSHA 29 CFR 1910 and 1926 User Instruction Manual for T700000XR, T100108, T410060, T100008B, and T200007. WARNING! Compliant fall protection equipment must only be used as it was designed and adhere to the hierarchy of controls as discussed in ANSI Z359.2.
-
Page 2: General Safety Information
GENERAL SAFETY INFORMATION These User Instructions are not to be removed except by the user of this equipment. Current User Instructions must always be available to the user. WARNING! Failure to follow all instructions and limitations on the use of 3-Way Self-Retracting Lifeline with Rescue(3-Way SRL-R) or Tripod System may result in serious personal injury or death. -
Page 3: Use Instructions And Limitations
After a fall or rescue occurs with the system, immediately remove from service until a “competent person” can make the determination for reuse or disposal. Werner Co. will provide design information upon request. Field serviceability testing is not required and is not recommended to be performed by the user. - Page 4 18. REPAIRS / ALTERATIONS: Only Werner Co., or persons or entities authorized in writing by Werner Co., may make repairs or alterations.
-
Page 5: Connection Requirements
OSHA states: Anchorages used for attachment of personal fall arrest equipment shall be independent of any anchorage being used to support or suspend platforms and capable of supporting at least 5,000 pounds (22.2 kN) per employee attached, or shall be designed, installed, and used as part of a complete personal fall arrest system which maintains a safety factor of at least two;... -
Page 6: System Components
ImItatIons All components and subsystems used with the Tripod System have been tested as part of a complete system. Only components and subsystems approved by Werner Co. are to be used with the Tripod System. : t100108 rIpod The Tripod extends from 58 inches (1.5 m) to 97 inches (2.5 m) for installation over openings with a maximum diameter of 22 inches (.5... -
Page 7: Mounting Bracket
Users must have a rescue plan, and the means to implement it, that provides for the prompt rescue of employees in the event of a fall or assures that employees are able to rescue themselves. The user must read and understand these user instructions, as well as the user instructions for every component and subsystem of the Tripod system. - Page 8 Irect abLe Direct the cable through the Tripod 1. Re-direct the cable down the center of the tripod using one Head Pulley or Carabiner and Pulley of the following pulleys: 1.1 Tripod Head Pulley: remove the pin on the head pulley and feed the cable into the sheave on the head pulley.
-
Page 9: Required Clearance
Eye Bolt Anchorage nchorage onnectIon 1. The Eye Bolt anchorage connectors can be used with compliant fall arrest systems. 2. The direction of loading of all fall protection systems attached to the Energy Absorbing Tripod must be downward, vertical, and remain within the legs of Length of Anchorage Connector Lanyard 1/2 ft. -
Page 10: Inspection And Maintenance
Exposed red on the 3-Way SRL-R snap hook is the indicator that the SRL has been subjected to the forces of arresting a fall. Remove from service and send back to Werner Co. or authorized service... -
Page 11: Cleaning And Storage
center for inspection and repair. All equipment must be free of corrosion, chemical attack, alteration, excessive heating or wear. All snap hooks and carabiners must be able to self-close and lock. All hardware must be free of cracks, sharp edges, deformation, corrosion, or any evidence of defect. Check the operation of the 3-Way SRL-R by pulling smoothly on the lifeline, then pulling sharply on the lifeline to engage the locking mechanism. - Page 12 LABELS P/N 122093-01 P/N 122093-02 P/N 122093-02 Werner Co. Fall Protection 555 Pierce Road, Suite 300, Itasca, IL 60143 724-588-2000 • 888-523-3371 toll free • 888-456-8458 fax PN113190-02 ©2021 Werner Co. Rev B 8/20...
Need help?
Do you have a question about the T700000XR and is the answer not in the manual?
Questions and answers