JVC JY-HD10 Instructions Manual page 73

Other problems
SYMPTOM
26. The CHARGE indicator on the
AC Power Adapter/Charger
does not light.
27. "SET DATE/TIME!" appears.
28. There is no picture.
29. Some functions are not
available using the MENU
Wheel.
30. Files stored in the memory
card cannot be deleted.
31. When the image is printed
from the printer, a black bar
appears at the bottom of the
screen.
32. When the camcorder is
connected via the i.LINK
connector, the camcorder does
not operate.
33. The rear of the LCD monitor is
hot.
34. Images on the LCD monitor
appear dark or whitish.
POSSIBLE CAUSES
26. • The temperature of the
battery is extremely high/low.
• Charging is difficult in places
subject to extremely high/
low temperatures.
27. • The built-in clock's
rechargeable lithium battery
is discharged.
• The previously set date/time
is erased.
28. • The camcorder is not getting
power, or some other
malfunction exists.
29. • The Power Switch is set to
"A".
30. • Files stored in the memory
card are protected.
31. • This is not a malfunction.
32. • The i.LINK cable was
plugged/unplugged with
power turned on.
33. • The light used to illuminate
the LCD monitor causes it to
become hot.
34. • In places subject to low
temperature, images become
dark due to the
characteristics of the LCD
monitor. When this happens,
the displayed colors differ
from those that are actually
recorded. This is not a defect
of the camcorder.
• When the LCD monitor's
fluorescent light reaches the
end of its service life, images
on the LCD monitor become
dark. Consult your nearest
JVC dealer.
CORRECTIVE ACTION
26. • To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C (50°F to 95°F).
( pg. 78)
27. • Connect the camcorder to an
AC outlet using the AC Power
Adapter/Charger for over 24
hours to charge the clock's
lithium battery. (
28. • Turn the camcorder's power
off and on again. (
29. • Set the Power Switch to "M".
( pg. 16)
30. • Remove protection from the
files stored in the memory
card and delete them.
( pg. 31 – 32)
31. • By recording with "OIS"
activated ( pg. 35, 37) this
can be avoided.
32. • Turn the camcorder's power
off and on again, then
operate it.
33. • Close the LCD monitor to
turn it off or set the Power
Switch to "OFF", and let the
unit cool down.
34. • Adjust the brightness and
angle of the LCD monitor.
( pg. 14, 15)
CONTINUED ON NEXT PAGE
73
EN
pg. 17)
pg. 16)