Connecting an antenna or cable TV (no box)
To connect an antenna or cable TV (no box):
1 Make sure that your TV's power cord is
unplugged, and all connected equipment is
turned off.
2 Connect a coaxial cable to the ANT/CABLE jack
on the back of your TV and to the antenna or
cable TV wall jack.
Back of TV
3 Plug your TV's power cord into a power outlet,
then turn on your TV.
4 Go through the setup wizard on page 21.
Notes
•
Use a coaxial cable to eliminate interference and
noise from radio waves.
•
Do not bundle the coaxial cable with the power
cord or other cables.
•
If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
14
NS-42L780A12/NS-46L780A12/NS-55L780A12 Insignia 42"/46"/55" LCD HDTV, 1080p
Coaxial cable
www.insigniaproducts.com
Connecting a DVD or Blu-ray player
Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1 Make sure that your TV's power cord is
unplugged and the DVD or Blu-ray player is
turned off.
2 Connect an HDMI cable (not included) to an
HDMI jack on the back or side of your TV and to
the HDMI OUT jack on the DVD or Blu-ray
player.
Back of TV
3 Plug your TV's power cord into a power outlet,
turn on your TV, then turn on the DVD or Blu-ray
player.
4 Press INPUT to open the Input Source list.
5 Press
or
to highlight HDMI 1, HDMI 2, or
HDMI 3, then press ENTER.
Note
You can also press HDMI repeatedly to select the
DVD or Blu-ray player.
DVD or Blu-ray player