Download Print this page
Niles SCW-2A Installation & Operation Manual

Niles SCW-2A Installation & Operation Manual

Wall-mounted, speaker volume control with a/b amplifier selector

Advertisement

Quick Links

I N S T A L L A T I O N & O P E R A T I O N G U I D E
SCW-2A
Wall-Mounted, Speaker Volume Control
with A/B Amplifier Selector
A AMPLIFIER B
INTRODUCTION
The Niles SCW-2A is a wall-mounted stereo volume control for remote
speakers that enables the user to select between two different sound
sources. The unit is ideal for both home and commercial sound installa-
tions. A ten position rotary switch controls the volume of the system. Use
of an auto transformer instead of an L-Pad assures minimal internal power
dissipation with virtually no power wasted as heat.
www.nilesaudio.com
Niles Audio Corporation
12331 S.W. 130 Street Miami, Florida, 33186 Tel: (305) 238-4373 Fax: (305) 238-0185
© 1999 Niles Audio Corporation. All Rights Reserved. Note: Because Niles believes in constantly improving its
products, Niles reserves the right to change product specifications without notice. Niles, the Niles logo and
Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation.
Printed in USA 3/97 DS 00018 B
B
H
F
A
®
L E N D I N G
I G H
I D E L I T Y
A N D
R C H I T E C T U R E

Advertisement

loading
Need help?

Need help?

Do you have a question about the SCW-2A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Niles SCW-2A

  • Page 1 12331 S.W. 130 Street Miami, Florida, 33186 Tel: (305) 238-4373 Fax: (305) 238-0185 © 1999 Niles Audio Corporation. All Rights Reserved. Note: Because Niles believes in constantly improving its products, Niles reserves the right to change product specifications without notice. Niles, the Niles logo and Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation.
  • Page 2 (refer to the diagram on the next page for details) Speaker Out L+ L- R- R+ There are three sets of wires on the rear of the SCW-2A. Two sets come off the Amplifier "B" circuit board via plug-in connectors. These two sets are the connections for amplifier A and amplifier B.