Daza Optiseat 9020 Quick Start Manual

9020/9021/9120 PRO –
Daza Optiseat
V 2024 – 1.1
QUICKSTART GUIDE
REPLACE THE BATTERY
The battery of the Optiseat will last approximately 6 years. When the battery is
almost depleted, the Optiseat will emit two short beeps every minute upon
activation to alert you. If the Optiseat is held vertically, it will also emit two
short beeps. Once the low battery warning is triggered, the proper functioning
of the Optiseat cannot be guaranteed. It is advised not to use the Optiseat and
to replace it with another one until the battery is replaced. Please contact your
supplier for assistance, as the battery cannot be replaced by the user.
The 9020 PRO / 9120 PRO models do not have a built-in DAZA transmitter.
Storing
Instead, they are equipped with a transmitter that directly triggers an alarm on
the system installed in the facility. If the alarm system indicates a low battery,
it means the transmitter's battery is depleted, not the Optiseat's. Have this
battery replaced as soon as possible.
GETTING STARTED
General Information:
The wireless Optiseat alerts when someone
stands up from a chair. If a person stands up for
more than the set time, the Optiseat will make an
alarm.
First installation:
1) Rotate the Optiseat once from the horizontal
position.
2)
Place the Optiseat in the chair, making sure
that the label is positioned at the back of the
chair.
3)
The Optiseat will automatically activate after
10 seconds when someone sits on it and is
ready for use immediately. Activation is
confirmed by a beep.
NOTE! Make sure that the Optiseat does not
lie bent on a chair!
DAILY USE
Usage:
When the Optiseat is on, it
automatically activates after 5
seconds when someone sits on it.
Canceling the Alarm:
When someone stands up, the
Optiseat will emit an acoustic signal
during the last 30 seconds of the set
time (see table). If the person sits
back down within that time or if the
cushion is flipped over, the alarm
will be canceled.
If the cushion has been flipped over
to cancel the alarm, it does not
need to be flipped back.
CLEANING AND DISINFECTION
Cleaning DAZA equipment is simple.. Turn off the device to prevent triggering an alarm during
cleaning. Use a damp cloth. If the device is very dirty, rinse the cloth intermittently. Afterward,
you can let it air dry or dry it with a clean cloth.
The following substances can be safely used:
Water
Disinfectants, such as chlorine 1000 ppm and chlorine 250 ppm
70% alcohol
Never use the following for cleaning:
Bleach
Harsh, corrosive cleaning agents
Cleaning agents containing ammonia or acetone
Soapy substances, as these can leave residues.
Apply the cleaning agent of your choice to a cloth so that it becomes slightly damp. Do not
spray or pour the cleaning agent directly onto the cushion. Never immerse the product, wash it
in a washing machine, dry it in a tumble dryer, and be careful with the zipper of the cushion. By
following these cleaning instructions, the device will remain in optimal condition.
TURN OFF
Complete Shutdown
Hold the cushion vertically and
press the Optiseat three times in
the center of the cushion with the
palms of your hands. Wait for the
shutdown to be confirmed by a
beep.
NOTE!
It is not necessary to deactivate the
Optiseat.