Tyco R/C REVOLVER Owner's Manual page 3

I. BATTERY INSTALLATION
I. BATTERY INSTALLATION
(Batteries not included)
VEHICLE
1.
Lift tab on bottom side to open Power Pack cover and
insert 4 "AA" batteries, with polarity (+/-) as shown
inside Power Pack.
2.
Slide Power Pack into back of vehicle up to the spring
loaded contacts. Push in while turning Power Pack
Release Latch UP or counter-clockwise to lock Power
Pack in place.
3.
To remove Power Pack, turn Power Pack Release Latch
down or clockwise (see page 1). Slide out Power Pack.
TRANSMITTER
1.
Slide battery door open. Install one 9-volt
battery, with polarity (+/-) as shown, inside
battery compartment.
2.
Replace battery door.