BTECH BS-PTT Pairing Instructions

BS-PTT wireless PTT usage and pairing instructions
*Requires wireless hand microphone or helmet microphone to use*
Wireless PTT (only used with our company's N series radio equipment)
The wireless PTT has been waterproofed in the factory and can adapt to the
complex outdoor use environment.
Wireless PTT status indicator: the newly enabled wireless PTT, click the PTT
button, the indicator flashes quickly to enter the pairing state. Press the PTT
button after pairing, the indicator light flashes slowly after connection fails, try
to connect again within 1-2 seconds. Still unable to connect, the wireless PTT
enters the pairing status indicator flashes quickly.
Wireless PTT battery use and replacement: This product uses CR1632 button
battery power supply, you can open the APP device status bar to view the
battery voltage during connection and use, please replace the battery when
the battery voltage is too low or can not be used. To replace the battery,
unscrew the wireless PTT cover in the direction shown in the figure above,
push out the battery with a non-metallic rod (remember the battery direction),
reinstall the battery in the correct direction (the battery positive corresponds
to the positive of the module), check the correctness, and then replace the