Gigabyte GA-MA69G-S3H User Manual page 78

B. Copying the driver for Windows Vista
Step 1: Insert the prepared startup disk and motherboard driver disk for Windows Vista in your system.
Boot from the startup disk. Once at the A:\> prompt, change to your optical drive (example: D:\>). At the
D:\> prompt, type the following command to enter the folder where the RAID/AHCI driver is located.
Press <Enter> after entering the command (Figure 4):
cd \chipset\rs690\vista\packages\drivers\sbdrv\sb6xx\raid\lh
(Note) The LH folder contains the RAID/AHCI driver for 32-bit Windows Vista; to install 64-bit Windows
Vista, please change the directory to the LH64A folder.
Step 2: After entering the folder, type the following command to copy the driver to the location you wish
to save the driver (e.g. A:) and press <Enter>
copy *.* a:
After copying the driver, in the location where you save the driver (e.g. A:), you should see the driver
files similar to that in Figure 5.
D:\>cd \chipset\rs690\vista\packages\drivers\sbdrv\sb6xx\raid\lh
D:\CHIPSET\RS690\VISTA\PACKAGES\DRIVERS\SBDRV\SB6XX\RAID\LH>copy *.* a:
Figure 4
(Note) For users without a startup disk:
Use an alternative system and insert the motherboard driver disk. In your optical drive
folder, go the following directory:
\Chipset\RS690\Vista\Packages\Drivers\SBDrv\SB6xx\RAID\LH (Figure 6).
Copy all the files in the folder to the location you want (e.g. floppy disk).
GA-MA69G-S3H Motherboard
A:\>dir
Volume in drive A has no label
Directory of A:\
AHCIX86S CAT 17,858 01-20-07 1:50
AHCIX86S INF 6,647 01-03-07 9:35
AHCIX86S MSI 71,680 02-08-07 7:27
AHCIX86S SYS 110,592 12-28-06 18:51
4 file(s) 206,777 bytes
0 dir(s) 1,250,816 bytes free
A:\>
Figure 5
Figure 6
- 78 -