Gigabyte GA-8I865PE-TW User Manual page 42

SATA Port0 Configure as
IDE Pri. Master
IDE Pri. Slave
IDE Sec. Master
IDE Sec. Slave
SATA Port0
SATA Port1
SATA Port1 Configure as
The values depend on SATA Port0.
USB Controller
Enabled
Disabled
USB 2.0 Controller
Disable this function if you are not using onboard USB 2.0 feature.
Enabled
Disabled
USB Keyboard Support
Enabled
Disabled
USB Mouse Support
Enabled
Disabled
AC97 Audio
Auto
Disabled
Onboard H/W LAN
Enabled
Disabled
Onboard Serial Port 1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Onboard Serial Port 2
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
GA-8I865PE-TW Motherboard
Remap SATA Port 0 to IDE primary Master.
Remap SATA Port 0 to IDE primary Slave.
Remap SATA Port 0 to IDE secondary Master.
Remap SATA Port 0 to IDE secondary Slave.
SATA controller set to SATA port0. As this mode, it support by WinXP or later
OS only. (Default value)
SATA controller set to SATA port1. As this mode, it support by WinXP or later
OS only.
Enable USB Controller. (Default value)
Disable USB Controller.
Enable USB 2.0 controller. (Default value)
Disable USB 2.0 controller.
Enable USB keyboard support.
Disable USB keyboard support. (Default value)
Enable USB mouse support.
Disable USB mouse support. (Default value)
Enable onboard AC'97 audio function automatically. (Default value)
Disable this function.
Enable Onboard H/W LAN function. (Default value)
Disable this function.
BIOS will automatically setup the port 1 address.
Enable onboard Serial port 1 and address is 3F8. (Default value)
Enable onboard Serial port 1 and address is 2F8.
Enable onboard Serial port 1 and address is 3E8.
Enable onboard Serial port 1 and address is 2E8.
Disable onboard Serial port 1.
BIOS will automatically setup the port 2 address.
Enable onboard Serial port 2 and address is 3F8.
Enable onboard Serial port 2 and address is 2F8. (Default value)
Enable onboard Serial port 2 and address is 3E8.
Enable onboard Serial port 2 and address is 2E8.
Disable onboard Serial port 2.
- 38 -