Page 6
Step 2B Assemble (2) Two 8' Side Wall Frames continued If you are adding additional windows or doors, frame-in rough opening(s) per manufacturer's instructions. ,@ Jnst:55 K]L se#en =reZ;)t B:55 st)&s CetBeen t8e t<= :n& C<tt<9 =5:tes@ a:i5 t8e tre:te& C<tt<9 =5:te t<...
Page 7
Step 4 Assemble (2) Two 12' Side Wall Frames -@ 7ri9. if necessary. K,L tB< ,30Z-,2 C<:r&s K<ne Bi55 Ce tre:te&L t< : 5engt8 <D -00d@ M<siti<n t8e C<:r&s t<get8er :n& in&i;:te Bit8 2g2 9:rRs B8ere t8e B:55 st)&s Bi55 Ce 5<;:te&@ 144"...
Page 8
Step 5 Assemble 15'-5" Front wall Door Frame Instructions show a suggested location for a 24"x36" window. (&e)st st)& s=:;ing iD n< Bin&<B <r iD : &iDDerent siYe Bin&<B B:s =)r;8:se&@ ( B:5RZin &<<r ;:n :5s< Ce inst:55e& iD &esire&@ -@ C)t K,L tB<...
Page 9
Step 6 Set Wall Frames Front and back wall frames are positioned between long side walls. -@ Jnst:55 <ne <D t8e f,Z-c,d re:r B:55 Dr:9es :g:inst insi&e <D : T2 si&e B:55 Dr:9e@ IMPORTANT: Xrient en& 9:rRe& Bit8 : 2C2 t< ;<rner@ Ee;)re Dr:9es t<get8er :t t8e ;<rner )sing K0L D<)r -/& sinRers@ 4r:;e B:55s Bit8 =reZ;)t st)&s@ ,@ Jnst:55 t8e <t8er f,Z-c,d re:r B:55 Dr:9e t<...
Page 10
Step 7 Install 2x4 Tie Plates -@ Jnst:55 : -12 5<ng ,30 <n t8e C:;R B:55@ Ase -/& sinRers s=:;e -1d :=:rt t< se;)re tie =5:tes@ ,@ !e=e:t t< inst:55 : -12 5<ng ,30 tie =5:te <n t8e <==<site Dr<nt B:55@ 8' Long 2x4 Tie Plate 16' Long 2x4 Tie Plate Back Wall Frames...
Page 12
Step 9 thru 11 Steps not needed with this size and model. Step 12 Install Stairs IMPORTANT: Go now to the instructions in the stair kit book to install the stairs, floor joist and flooring.
Page 13
Step 13A Assemble Rear Gable Assemble the roof gables and trusses on the center of the loft floor. This will make it easier to stand the gable upright over the lower wall. -@ C)t K,L tB< ,30Z-/2 C<:r&s t< : 5engt8 <D f]Z-c,d@ M<siti<n t8ese ,30s. on edge :n& C)tt t<get8er@ ,@ M<siti<n K,L tB<...
Step 29 Install Doors If your door opening is out of square, the space around the doors will not be even. You can remove and re-position the side trim to make allowances for this. The side trim does not have to be flush with the frame of the door opening.
Need help?
Do you have a question about the the Virginia and is the answer not in the manual?
Questions and answers