Page 1
AIR HOSE REEL OWNER & ASSEMBLY MANUAL ENGLISH ITEM# 75462 REV 10.29.2024...
Page 2
Thank you for choosing a Forney product. Fort Collins, CO 80525 Since 1932, Forney has been at the forefront of innovation and excellence in all facets of our business. J.D. Forney was an U.S. Facilities: entrepreneur who invented the instant-heat soldering iron and the - Fort Collins, CO first 110-volt Arc Welder.
Page 3
Industries will repair or replace defective products at no charge to you! When you call Forney’s Expert-Tech™ team, you will speak to a trained product and application expert. Forney’s primary goal is to get your unit up and running in as little time as possible. In fact, the majority of issues can be fixed over the phone! Please be near your unit when you call, so the Forney technician can guide you.
BEFORE INSTALLING, OPERATING OR CARRYING OUT MAINTENANCE ON THE UNIT, READ THE CONTENTS OF THIS MANUAL CAREFULLY, PAYING PARTICULAR ATTENTION TO THE SAFETY RULES AND HAZARDS. In the event of these instructions not being clear, please contact your Forney Authorized Dealer or Forney Customer Service 1-800-521-6038. Symbols Legend MEANING...
General Safety • SAVE THESE INSTRUCTIONS. Read and understand all instructions, precautions and safety warnings before operating this equipment to avoid injury or property damage. • Some dust contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm such as asbestos, lead and lead-based paint.
Installation Instructions 1. Remove bag of mounting hardware • If mounting into masonry/concrete walls, retain the included anchors for Step 5. • If mounting into wood, obtain 3/8” x 1-½” lag screws (or larger) and 1” washers. 2. Remove the air hose reel from the packaging 3.
Adjusting the Guide Arm (As Needed) 1. Pull out 3-4’ of hose and allow the reel to lock in position 2. Remove the four-bolt connecting guide arm to the support post, retain bolts 3. Rotate guide arm in 90° increments until it reaches the desired position. Replace the 4-bolts and tighten Adjusting the Hose Stopper (As Needed) The hose stopper determines the length of hose that remains outside of the reel.
Need help?
Do you have a question about the 75462 and is the answer not in the manual?
Questions and answers