Advertisement
Quick Links
Chiller Installation Instruction
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING
OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
This product must be installed by a fully insured and licensed HVAC installer.
The chiller uses R410A refrigerant. WOODBRIDGE does not offer nor is responsible for refilling the refrigerant. Please hire a
fully insured and licensed HVAC installer for maintenance, refrigerant refill, troubleshoo�ng, and repair of the chiller.
We are not responsible for local codes compliance for this product. Building and plumbing codes may vary from state-to-state
in accordance to your loca�on. We are not responsible for providing any compliance cer�fica�ons. Under no circumstances
we shall not be liable for any incidental damage sustained in connec�on with this product. Neither manufacturer, nor
distributor, nor retailer is responsible for water damage or flood caused by the usage of this product. Under no circumstances
we shall not be liable for any and all fees, cost of installa�on/reinstalla�on/removal, subsequent damage or transporta�on
costs in case of the product defect.
2 PEOPLE ARE REQUIRED TO LIFT AND DURING
TWO PEOPLE
LIFT REQUIRED
ENTIRE INSTALLATION OF THIS PRODUCT
www.woodbridgebath.com
Model: IC 2.0
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Woodbridge IC 2.0
Summary of Contents for Woodbridge IC 2.0
- Page 1 This product must be installed by a fully insured and licensed HVAC installer. The chiller uses R410A refrigerant. WOODBRIDGE does not offer nor is responsible for refilling the refrigerant. Please hire a fully insured and licensed HVAC installer for maintenance, refrigerant refill, troubleshoo�ng, and repair of the chiller.
-
Page 2: Working Principle
1.Working principle The chiller cools down the water with the compressor inside. Then, the water circulates back to the wooden tub to lower the temperature of the tub water. In certain models, the chiller can also warm up the water with its built-in heater. Water Circula�on: Wooden Tub ->... - Page 3 Wall 23 5/8″ Air inlet location Chiller 59″ Air outlet location Wall Chiller power distribu�on ① Please take safety precau�ons before powering any connec�ons. ② Connec�on or replacement of wiring should comply with electrical specifica�ons and should be performed byrofessionals. ③...
- Page 4 ② Check and make sure the tub inlet is unobstructed(filter screen built-in) every �me before usage. The water inlet should be kept unobstructed, and the tub is kept clean. (there should be no garbage) Clean the tub filter screen (built-in) before use, lt can help prevent small debris from going into the chiller. Regularly cleaning the tub filter screen can prolong the opera�onal life of the chiller.
- Page 5 4.Parameter modifica�on Press and hold (set key) for 5 seconds. When the nixie tube displays PD, press (up key) or (down key) to enter the correct password, and then press (set key) to confirm. A�er the password is correct, you can enter the menu.
- Page 6 5.Overall Appearance And Size Water outlet Water inlet Axial fan DN15 ID18.63mm. Temperature controller Full range of product models and sizes MODEL 9000BTU 12000BTU 18000BTU Se�ng temperature range 0~40℃(Factory default 3℃) FIltera�on Folded paper 30μm O-zone/UV 30~50mg/h Inflow/Ou�low size DN 15 Inner Thread Water pump type Non-self priming Note: the above specifica�ons may subject to change without prior no�ce.
-
Page 7: Installation Precaution
Indicator Light Icon name Hengliang representa�ve Ex�nguish represents Flashing representa�ve Refrigera�on lamp Cooling Stop refrigera�on Compressor is delaying constant temperature Target temperature reached Not at target temperature Hea�ng lamp Hea�ng in progress Stop hea�ng Compressor is delaying Defrost lamp Defros�ng Stop defros�ng Compressor is delaying Networking lamp... - Page 8 FAQ: ① Why has condensate water come out from the chiller? This is caused by temperature difference between the inside and outside of the chiller pipe system. ② Why has smoke coming out from the chiller? When chiller is defros�ng under the heater mode, it may generate smoke-like vapors. This is normal. ③...
-
Page 9: Useful Tips
Useful Tips 1. lt is normal to have condensa�ons on the hoses, chiller housing cover, or around the tub. The condensa�ons happen when these tub/chiller parts are colder than the air around. 2. The fan in the chiller starts running 3 minutes a�er the machine opera�on is normal. 3. - Page 10 DO NOT USE: Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch Retain these installation instructions for future reference! Thank you for using WOODBRIDGE products! WOODBRIDGE California (Norwalk)Distribu�on Center 15600 Blackburn Ave,Norwalk,CA 90650 New Jersey (Somerset)Distribu�on Center...
- Page 11 www.woodbridgebath.com...
- Page 12 www.woodbridgebath.com...
Need help?
Do you have a question about the IC 2.0 and is the answer not in the manual?
Questions and answers