Advertisement
Quick Links
TDS | QUICK GUIDE
Victron MultiPlus
Inverter/Charger Battery Back-Up - 500VA to 3000VA
© Newton Waterproofing Systems
Newton House, 17-19 Sovereign Way
Tonbridge, Kent, TN9 1RH
www.newtonwaterproofing.co.uk
tech@newtonwaterproofing.co.uk
+44 (0)1732 360 095
Revision 2.0 - 01
st
Opening Hours:
Monday to Thursday 8:00am - 5:30pm
Friday 8:00am - 5:00pm
®
July 2024
Advertisement
Related Manuals for Newton Waterproofing Victron MultiPlus
Summary of Contents for Newton Waterproofing Victron MultiPlus
- Page 1 ® Victron MultiPlus Inverter/Charger Battery Back-Up - 500VA to 3000VA Revision 2.0 - 01 July 2024 www.newtonwaterproofing.co.uk © Newton Waterproofing Systems Opening Hours: tech@newtonwaterproofing.co.uk Newton House, 17-19 Sovereign Way Monday to Thursday 8:00am - 5:30pm Tonbridge, Kent, TN9 1RH +44 (0)1732 360 095...
- Page 2 INTRODUCTION INTRODUCTION IMPORTANT INCLUDED WITHIN THE PACKAGING This Quick Guide should be read in conjunction with the Victron Installation Manual that is included in The inverter is supplied in two boxes. Within the larger box is the inverter. Within the second box are the box.
-
Page 3: Installation
WARNINGS & INSTALLATION INSTALLATION WARNING: ELECTRIC SHOCK HAZARD ENVIRONMENT The product is used in conjunction with a permanent energy source (battery). Input and/or output This product should be installed in a heat-resistant, dry, habitable environment. terminals may still be dangerously energised, even when the equipment is switched off. Always switch off Prevent the presence of chemicals, synthetic components, curtains or other textiles, etc., in the immediate the AC supply and the battery isolator switch before carrying out maintenance or servicing the product. - Page 4 INSTALLATION INSTALLATION FIG A - 500VA & 800VA AC POWER OUT TO PUMP OR CONTROL PANEL 1. Remove the right (AC OUTPUT) wiring block from the base of the inverter (item J) 2. Wire AC OUTPUT with correctly rated mains cable to the AC isolator switch and to the RCD fused spur.
-
Page 5: Operation
INSTALLATION INSTALLATION TEMPERATURE SENSOR LED INDICATIONS - Switch position - CHARGER ONLY Insert the Temperature Sensor cable into terminal D of the Inverter/Charger. WARNING: If the Temperature Sensor Cable is not correctly fitted, the charger will not charge the batteries. OPERATION The Inverter/Charger is now ready to use. -
Page 6: Troubleshooting
On delivery, the unit has been programmed by Newton ready for use as part of a Newton Pumping System with charging voltages matched to the battery bank size also supplied by Newton Waterproofing Systems. There is no need to change any of the settings. - Page 7 AC fuse sizes etc. Please refer to the installation information on pages 5-9 of this guide for more information. Newton Waterproofing Systems reserve the right to update product literature at any time. Please always refer to our website for the latest versions.
Need help?
Do you have a question about the Victron MultiPlus and is the answer not in the manual?
Questions and answers