Battery Drain Protection; Setting The Cut-Off Voltage - NanoCam Plus NCP-SHWK User Manual

ACCESSORIES
1. Cable Ties x 4

2. BATTERY DRAIN PROTECTION

The hardwire kit will protect your dashcam from draining your vehicle's
battery. If your vehicle's battery voltage gets too low, the NCP-SHWK will stop
powering your camera to save power.
2.1 SETTING THE CUT-OFF VOLTAGE SWITCH
Set the cut-off voltage to the preferred voltage limits before the hardwire kit
cuts off the output.
There are four protection bands set within the hardwire kit for your selection.
For 12V Batteries
The protection voltages are 11.8V / 12.0V / 12.2V / 12.4V.
The 12.2V setting is recommended for general driving conditions.
For 24V Batteries
The protection voltages are 23.6V / 24.0V / 24.4V / 24.8V.
The 2.4V setting is recommended for most users in general driving conditions.
The hardwire kit will identify the lead acid battery type automatically (12V or
24V) and protect your battery from draining accordingly.
Setting the Parking Monitor Switch
Default (High) is automatically selected to comply with all Nanocam dash
camera models. For other brands of dashcams, consult the manufacturer to
ensure your dash camera is compatible with a 3-wire hardwire kit, and what
the appropriate Parking Monitor setting is (High or Low).
Note: Not all Nanocam models support the Parking Monitor function.
Please check individual model specifications. Models without a Parking Mode
function will have continuous recording irrespective of the accessories being
on or off.
5