Chapter 2
Installation
Mounting the Router
Mounting on a Table
Caution
Mounting on a Wall
78-14781-02
You can mount the router on one of the following surfaces:
•
Table or other horizontal surface
Wall or other vertical surface
•
Place the router firmly on a table, and perform the procedure given in the
"Installing the Router" section on page
Do not cover or obstruct the router vents, which are located on the sides of the
router. If the vents are covered or obstructed, overheating could occur and cause
damage to the router.
You can mount the router on a wall or other vertical surface by using the molded
mounting brackets on the bottom of the router and two number-six, 3/4-in.
(M3.5 x 20 mm) screws. You must provide the screws.
mounting brackets.
Cisco 837 Router and SOHO 97 Router Hardware Installation Guide
Mounting the Router
2-10.
Figure 2-1
shows the
2-7