Casio FX-115ES PLUS User Manual page 41

• Be sure to input the X variable (S)(X)) when generating a number
table. Any variable other than X is handled as a constant.
• If you are using a single function, input a function in the format
only.
• The following cannot be used in the function: Pol, Rec, ∫,
3. In response to the prompts that appear, input the values you want to use,
pressing = after each one.
For this prompt: Input this:
Start?
End?
Step?
• Inputting the Step value and pressing = generates and displays the
number table in accordance with the parameters you specified.
• Pressing A while the number table screen is displayed will return to
the function input screen in step 2.
To generate a number table for the functions
g x x
2
( ) = −
B
1N(SETUP)c5(TABLE)2(f(x),g(x))
• Pressing = without inputting anything for
table based on
Note: • The maximum number of rows in the generated number table depends
on the setup menu table setting. Up to 30 rows are supported for the "f(x)"
Input the lower limit of X (Default = 1).
Input the upper limit of X (Default = 5).
Note: Make sure that the End value is always
greater than the Start value.
Input the increment step (Default = 1).
Note: The Step specifies by how much the Start
value should be sequentially incremented as the
number table is generated. If you specify Start = 1
and Step = 1, X sequentially will be assigned the
values 1, 2, 3, 4, and so on to generate the number
table until the End value is reached.
1
for the range –1
2
S)(X)x+ 1 ' 2
f x
( ) only.
S)(X)x- 1 ' 2
=-1 =1 =0.5 =
x
1, incremented in steps of 0.5
N7(TABLE)
=
E-40
d/dx
f x x
( ) = 2 +
g x
( ) will generate a number
f x
( )
, Σ, Π.
1
and
2
Math Math
Math Math
Math Math
Math Math
Math Math